In Situ Arsenic Immobilization by Chemical Oxidation: Field Trial and Reactive Transport Modelling

Xianjun Xie,Kang Peng,Yanxin Wang,Junxia Li,Kun Qian,Yamin Deng,Yiqun Gan
DOI: https://doi.org/10.1016/j.jhydrol.2020.124645
IF: 6.4
2020-01-01
Journal of Hydrology
Abstract:In situ chemical oxidation (ISCO) can be used as a technique for in situ arsenic (As) removal from groundwater. NaClO as an oxidant was intermittently injected into an anoxic aquifer with high aqueous As and Fe concentrations which is located on the Jianghan Plain (JHP). The aim was to promote the formation of hydrous ferric oxide (HFO) and oxidize arsenite to arsenate, thus immobilization aqueous arsenate via adsorption and/or co-precipitation. A three-dimensional reactive transport model was developed to determine the hydrogeochemical processes responsible for As (im)mobilization during the field trial. The modeling results indicate that the variation of AsO33- concentration can be divided into adsorption non-equilibrium and adsorption equilibrium stage. In adsorption non-equilibrium stage, oxidation and accompanying adsorption onto the surface of HFO causes the rapid decrease of AsO33- concentration. However, the modeled AsO33- concentrations were lower than measured concentrations in adsorption equilibrium stage, which may be due to AsO33- desorption from the surface of HFO as advantages of other competitive ions. Comparison of field data and modeling results suggest the product of the oxidative hydrolysis of Fe2+(aq) in the field experiment was ferrihydrite. The concentration of total As was mainly affected by the HFO content and concentration of competitive adsorption ions in groundwater. The natural groundwater flow field led to a difference in the concentration of HFO upstream and downstream of the injection well, where the downstream well had a higher HFO content and lower total As concentration. HCO3- was the dominant surface species affecting the adsorption of AsO43- by HFO. There is more sorption site on HFO surface due to the oxidation of adsorbed Fe2+, and then resulted in an increase in adsorbed H2SiO3(aq) and Mg2+(aq) content on the surface of the HFO over the course of the experiment. The reactive transport modeling (RTM) results reasonably match with observed concentrations of hydrochemical ions, indicating RTM can explain the crucial chemical processes in this in situ As remediation trial, providing important technical guidance for similar remediation operations.
What problem does this paper attempt to address?