Abstract:Centrifugal spray deposition forming technology, which is used in the preparation process of near-net-forming billets, not only reduces the macroscopic segregation and refines the microstructures of billets but also has the characteristics of a rapid solidification structure. The trajectory, velocity, heat transfer and solidification of metal droplets granulated by the centrifugal force during flight will affect the shape, precision and microstructure of the billet. Therefore, it is necessary to study the dynamics and thermal history of droplets in flight. In this study, a single droplet is taken as the object. Considering the resistance of ambient gas, Newton's second law, classical nucleation theory, Newton's cooling law and the energy conservation equation were used to establish a dynamic model and heat transfer solidification model of liquid metal droplets during flight. The influence of the centrifugal disc speed on the diameter of granulated droplets was analyzed. The variation law of droplet flight trajectory and velocity was explored. The supercooling degree in metal droplet nucleation was quantified, and the influence of droplet diameter, superheat and other factors on heat transfer and solidification was revealed. The results show that the numerical calculation results are basically consistent with the previous research results. The trajectory of the droplet is parabolic during flight. The initial velocity of the droplet, the environmental gas resistance and the convective heat transfer coefficient are positively correlated with the rotating speed of the centrifugal disc; however, the droplet diameter is negatively correlated with the rotating speed of the centrifugal disc. The super cooling degree at the time of droplet nucleation and the flight time required for solidification are negatively correlated with the droplet diameter. Among them, the droplet diameter has a linear relationship with the solidification start time and a quadratic curve relationship with the solidification end time. The effect of superheat on the heat transfer and solidification of droplets is not obvious. The conclusions obtained can provide a theoretical basis for the determination of the preparation process parameters.

The Influence of the Interaction Between the Multiple Slag Droplets on the Solidification Characteristics in Humid Air

Study on the Solidification Characteristics of Molten Slag Droplets Cooled by Mixed Cooling Medium

A Volatile Spray Zone Model and Experimentation in a Gas-Solid Fluidized Bed with Liquid Injection

Effect of droplet characteristics on liquid-phase distribution in spray zone of internal mixing air-mist nozzle

Theoretical Investigation of the Influence of Liquid Physical Properties on Effervescent Atomization Performance

Experimental Investigation of the Sedimentation Behavior of Metal Droplets in Liquid–liquid Systems

Lattice Boltzmann simulation of droplet solidification processes with different solid-to-liquid density ratios

Analysis of Factors that Influence the Evolution of Molten Droplets During Electroslag Remelting

Influence of Rotary Disk Configurations on Droplets Characteristics in Molten Slag Granulation for Waste Heat Recovery

Study on Flight Dynamics and Heat Transfer Solidification of Metal Droplets during Centrifugal Spray Deposition Forming Process

On the Role of Liquid Viscosity in Affecting Droplet Spreading on a Smooth Solid Surface

Numerical Simulation on the Motion Behavior of Micro-inclusions at the Steel–Slag Interface

Studies of splat morphology and rapid solidification during thermal spraying

Effect of drop size on the impact thermodynamics for supercooled large droplet in aircraft icing

Experimental Investigation of the Overlap Process in Metal Droplet Successive Deposition and Solidification

Dynamic Behavior of Droplet Impact on Laminar Superheated Particles

A Numerical Analysis Research on Earlier Behavior of Molten Droplet Covered with Vapor Film at the Stage of Triggering and Propagation in Steam Explosion

A numerical study on non-spherical droplet impact with solidification in additive manufacturing

Solidification process of hollow metal droplets impacting a substrate

A study on the solidification shapes of molten metal droplet impacting at low weber number

Analysis of the Development of the Solidification Shell in Airslip Mold