Abstract:Brake-by-wire technology is a development direction of the future automotive brake technology which has aroused extensive concern of domestic and foreign car manufacturers .Since the existing automotive electromechanical brake (EMB) was lack of wear compensation device which was specified in the national standard ,GB12676 — 2014 ,an innovative EMB with gap auto-matic adjustment function was designed .The mathematical models of drive motor , motor friction ,worm and gear ,ball screw and loading were established by MATLAB /Simulink .By building the EMB bench ,the braking performance differences between simulation and experiment were tested and analyzed under the signal of step ,triangle wave ,square wave and sinusoidal wave .The braking performances of EMB with the gap automatic adjustment function or nor were also tested and analyzed .The experimental results showed that the start-current of the EMB sys-tem had a "peak" characteristic and the clamping force was sensitive ,which could meet the bra-king requirements .According to the experimental data ,the parameter relations were concluded :the clamping force was linearly related to the locked-rotor current ,and the characteristics of cubic polynomial were met by the relationship between clamping force and screw displacement .The correctness of the mathematical model was verified by the simulation and experimental results .A theoretical basis for reducing the force sensor and other devices could be provided by the conclu -sion of parameters relational characteristics .The experimental outcome indicates that the gap au-tomatic adjustment function of the new EMB can guarantee that the brake gap and the response time are consistent at each time ,which can further improve the safety of brakes .

Simulation and Experimental Study of a New Electromechanical Brake with Automatic Wear Adjustment Function

Simulation and experimental research of a new automotive electromechanical brake system

Research on Modeling and Load Simulation Algorithm of Tracked Vehicle Braking System on Mu-Split Road Surfaces

An Experimental Study on Hysteresis Characteristics of a Pneumatic Braking System for a Multi-Axle Heavy Vehicle in Emergency Braking Situations

Modeling and Simulation of an Electromechanical Brake System

Clamping force control based on dynamic model estimation for electromechanical brakes

Electromechanical braking systems and control technology: A survey and practice

Wheel slip ratio control considering time delay characteristic for electro-mechanical braking system

Clamping force control of electro-mechanical brakes based on driver intentions

Control Strategy for Brake Clearance Adjustment of Electronic Mechanical Brake

Co-Simulation On Performance Evaluation Of A New Electronic Control Hydraulic Braking System

Slip ratio control based on adaptive fuzzy sliding mode for vehicle with an electromechanical brake system

Braking performance oriented multi-objective optimal design of electro-mechanical brake parameters

Study on Disc Brake Co-simulation for Motorcycle Braking Performance

Simulation and experimental investigation of vehicle braking system employing a fixed caliper based electronic wedge brake

Modeling, Control And Test Of A Novel Electronic Pneumatic Brake System

Modeling and Adaptive Control of the Electro-Hydraulic Braking System of Low-Floor Vehicle

Proof-of-Concept Design of Electronic Wedge Brake with Multi-Rollers

Simulation Experiment on Wind Turbine Soft Braking

Research on Electronic Brake Force Distribution and Anti-Lock Brake of Vehicle Based on Direct Drive Electro Hydraulic Actuator

Dynamic Load Emulation of Slip Ratio Control in Anti-lock Braking of a Front-axle-drive Electric Vehicle