Abstract:The reason that p-GaN gate normally-off high electron mobility transistor (HEMT) device is able to draw prevail interests is not only for its outstanding electric properties of low on-resistance and high thermal conductivity, but also for its applications under high frequency and high voltage. In HEMT devices, the setting of Al component in the AlGaN barrier layer is a key parameter to affect the formation of two-dimensional electron gas (2DEG) at the AlGaN/GaN heterojunction, and therefore directly determines the performance of the devices. This paper uses the Atlas module of the Silvaco-TCAD software to design and simulate p-GaN gate normally-off HEMT devices to investigate the effect of Al mole fraction content in the AlGaN barrier layer on the electrical performance, as well as the causes in terms of the conduction band energy structure diagram. The results show that the threshold voltage of the HEMT device decreases, the maximum saturation drain current increases, and the peak transductance of the HEMT device increases with increasing the Al content. In the off-state (zero gate voltage), the AlGaN/GaN potential well depth becomes deeper as the Al mole fraction increases, resulting in a lower driven force to rebuild the minimized 2DEG concentration in the GaN layer for switching from off-state to on-state, and this leads to a lower threshold voltage. While, in the on-state (5 V gate voltage), the deeper AlGaN/GaN potential well depth as the Al mole fraction increases, the higher of the 2DEG concentration of the GaN layer, leading to a higher maximum saturation output drain current. After optimization, the integrated electrical performance of the HEMT devices has been found best when the Al mole fraction content is about 0.25. The results obtained from the simulations are helpful for the experimental design of p-GaN gate normally-off HEMT devices

Influence of the Ratio of Gate Length to Source-Drain Distance on the Sensitivity of the AlGaN/GaN HEMT Based Chemical Sensors and Biosensors

Optimization of Gate Geometry Towards High-Sensitivity AlGaN/GaN Ph Sensor

The study of N-polar GaN/InAlN MOS-HEMT and T-gate HEMT biosensors

Enhancement of Sensing Performance of GaN-based MOS-HEMT Biosensors by Graded AlGaN Barrier

The Sensing Mechanism of InAlN/GaN HEMT

Measurement of piezoresistance coefficient with different gate voltages of GaN HEMT micro-accelerometer

High Sensitive pH Sensor Based on AlInN/GaN Heterostructure Transistor

Review of the AlGaN/GaN High-Electron-Mobility Transistor-Based Biosensors: Structure, Mechanisms, and Applications

High Sensitive pH Sensor Based on AlInN/GaN Heterostructure Transistor.

Ph Sensor Based on an AlGaN/GaN HEMT Structure

Effect of Device Geometry on Static and Dynamic Performance of AlGaN/GaN-on-Si High Electron Mobility Transistor

The Effect Of The Gate-Drain Distance On High Frequency And Noise Performance For Algan/Gan Hemt

Enhanced Stability and Sensitivity of AlGaN/GaN-HEMTs Ph Sensor by Reference Device

Influence of Transverse Geometry of Sidewall Gates on Characteristics of AlGaN/GaN Fin-HEMTs

Modeling and Experimental Study on Sensing Response of an Algan/Gan Hemt-Based Hydrogen Sensor

Simulation study on electrical properties of p-GaN gate normally-off HEMT devices affected by Al mole fraction in AlGaN barrier layer

Total ionizing dose effects in passivated and unpassivated AlGaN/GaN HEMTs

Tailoring the H2 gas detection range of the AlGaN/GaN high electron mobility transistor by tuning the Pt gate thickness

Influence of Gate Geometry on the Characteristics of AlGaN/GaN Nanochannel HEMTs for High-Linearity Applications

Investigation of High-Sensitivity Ph Sensor Based on Au-Gated AlGaN/GaN Heterostructure

Applications of AlGaN/GaN High Electron Mobility Transistor-Based Sensors in Water Quality Monitoring