Abstract:The reason that p-GaN gate normally-off high electron mobility transistor (HEMT) device is able to draw prevail interests is not only for its outstanding electric properties of low on-resistance and high thermal conductivity, but also for its applications under high frequency and high voltage. In HEMT devices, the setting of Al component in the AlGaN barrier layer is a key parameter to affect the formation of two-dimensional electron gas (2DEG) at the AlGaN/GaN heterojunction, and therefore directly determines the performance of the devices. This paper uses the Atlas module of the Silvaco-TCAD software to design and simulate p-GaN gate normally-off HEMT devices to investigate the effect of Al mole fraction content in the AlGaN barrier layer on the electrical performance, as well as the causes in terms of the conduction band energy structure diagram. The results show that the threshold voltage of the HEMT device decreases, the maximum saturation drain current increases, and the peak transductance of the HEMT device increases with increasing the Al content. In the off-state (zero gate voltage), the AlGaN/GaN potential well depth becomes deeper as the Al mole fraction increases, resulting in a lower driven force to rebuild the minimized 2DEG concentration in the GaN layer for switching from off-state to on-state, and this leads to a lower threshold voltage. While, in the on-state (5 V gate voltage), the deeper AlGaN/GaN potential well depth as the Al mole fraction increases, the higher of the 2DEG concentration of the GaN layer, leading to a higher maximum saturation output drain current. After optimization, the integrated electrical performance of the HEMT devices has been found best when the Al mole fraction content is about 0.25. The results obtained from the simulations are helpful for the experimental design of p-GaN gate normally-off HEMT devices

The Sensing Mechanism of InAlN/GaN HEMT

Analytical Model for AlGaN/GaN High Electron Mobility Transistor

On the Operation Mechanism and Device Modeling of AlGaN/GaN High Electron Mobility Transistors (Hemts)

The study of N-polar GaN/InAlN MOS-HEMT and T-gate HEMT biosensors

Numerical Simulation of AlXGa1-XN/AlN/GaN HEMT

Simulation study on electrical properties of p-GaN gate normally-off HEMT devices affected by Al mole fraction in AlGaN barrier layer

An Enhancement-Mode AlInN/GaN HEMTs Combining Intrinsic GaN Cap Layer and AlGaN Back Barrier Layer

Investigation on the sources of 2DEG in AlxGa1-xN/GaN HEMT

Numerical Simulation of Two-Dimensional Electron Gas Characteristics of a Novel (inxal1−xn/aln)mqws/gan High Electron Mobility Transistor

Influence of the Ratio of Gate Length to Source-Drain Distance on the Sensitivity of the AlGaN/GaN HEMT Based Chemical Sensors and Biosensors

High Sensitive pH Sensor Based on AlInN/GaN Heterostructure Transistor.

High Sensitive pH Sensor Based on AlInN/GaN Heterostructure Transistor

Electrical and Thermal Characteristics of AlGaN/GaN HEMT Devices with Dual Metal Gate Structure: A Theoretical Investigation

Influence of High-Temperature Aln Interlayer on the Electrical Properties of Algan/Gan Heterostructure and Hemts

Fabrication and Characterization of InAlN/GaN-based Double-Channel High Electron Mobility Transistors for Electronic Applications

Optimization of Two-Dimensional Electron Gases and I–V Characteristics for AlGaN/GaN HEMT Devices

Analysis of transconductance characteristic of AlGaN/GaN HEMTs with graded AlGaN layer

Normally-Off AlGaN/GaN High Electron Mobility Transistors with Thin and High Al Composition Barrier Layers

The Influence of 1nm AlN Interlayer on Properties of the Al0.3Ga0.7N/AlN/GaN HEMT Structure

Two-Dimensional Static Numerical Modeling and Simulation of AlGaN/GaN HEMT