Abstract:<p>Vehicle exhaust pipe is an excellent heat source and its integration with thermoelectric generators for thermo-electrical conversion has been recently attracting much attention. The methods of increasing power output include the parameter optimizations of the thermoelectric module material, thermoelectric module geometrical shape and exhaust gas property. Because of the coupling nature of these parameters, however, there is a lack of lateral comparison providing with the idea of which parameter gives the largest effect and which parameter combination gives the best power output performance. For this purpose, a novel hexagonal shaped housing has been developed for an engine exhaust thermoelectric generator unit to contain thermoelectric modules with higher temperature difference. The concept of hexagonal shaped housing provides a larger contact area which will increase the temperature differences applied on the hot and cold sides of the thermoelectric module. The thermoelectric generator unit performance has also been improved by the concept of the cross flow which will enlarge the high temperature difference area. Built with these two new concepts, an innovative engine exhaust thermoelectric generator unit has been designed, fabricated and tested.</p><p>The performance optimization of the thermoelectric generator unit has been conducted based on the validated simulation model. The identified key parameters include the number of thermocouples, geometric shape/curvature of the thermoelectric module, thickness of the thermocouples, thermoelectric module material, number of layers of thermoelectric modules, exhaust gas temperature and the thickness of the ceramic substrate. It suggests that four parameters need to be focused for optimization, which are the number of thermocouples, exhaust gas temperature, thermoelectric material and geometric shape/curvature. In order to reduce the complication brought by modifying other parameters, further, Optimized Systems 1, 2 and 3 with different optimized parameters are compared. It is found that a good trade-off between achieving high power output and avoiding unnecessary technical complexities and related cost increase can be reached for Optimised System 3 with 152 thermocouples and 480°C exhaust gas temperature.</p>

Temperature Gradient Characteristics and Effect on Optimal Thermoelectric Performance in Exhaust Power-Generation Systems

Modelling and Simulation Study of a Converging Thermoelectric Generator for Engine Waste Heat Recovery

Design and optimal coolant flow rate analysis of an annular water-cooled automotive exhaust-based thermoelectric generator

Thermoelectric Performance Evaluation and Optimization in a Concentric Annular Thermoelectric Generator under Different Cooling Methods

Performance analysis of a novel Two-stage automobile thermoelectric generator with the Temperature-dependent materials

Study of Different Heat Exchange Technologies Influence on the Performance of Thermoelectric Generators

Numerical analysis of thermoelectric power generation coupled with temperature-dependent material properties

Exploring the dynamic characteristics of thermoelectric generator under fluctuations of exhaust heat

Optimization Design of an Intermediate Fluid Thermoelectric Generator for Exhaust Waste Heat Recovery

Performance Investigation of a Thermoelectric Generator System Applied in Automobile Exhaust Waste Heat Recovery

Lateral comparison of the coupling parameters on the novel hexagonal shaped cross flow thermoelectric generator

Data Fitting and Analysis of Performance for Micro-thermoelectric Generator

Numerical Investigation and Optimization of a Hexagonal Thermoelectric Generator with Diverging Fins for Exhaust Waste Heat Recovery

Optimization of Thermoelectric Performance of Offset-strip Fin Type Exhaust Heat Exchanger

Optimal distribution of heat exchanger area for maximum efficient power of thermoelectric generators

Effects of Temperature-Dependent Thermal Properties and the Side Leg Heat Dissipation on the Performance of the Thermoelectric Generator

Measurement and Analysis for Performance of Micro-thermoelectric Generator

The Impact of the Heat Leakage Through Air Gap on Thermoelectric Generator Applied in Engine Waste Heat Recovery

Taguchi optimization and thermoelectrical analysis of a pin fin annular thermoelectric generator for automotive waste heat recovery

Performance evolution of thermoelectric modules under constant heat flux

Study of Thermal Insulation Materials Influence on the Performance of Thermoelectric Generators by Creating a Significant Effective Temperature Difference