Abstract:With the increased frequency of accidental and deliberate explosions, evaluating the response of civil infrastructure systems to blast loading has been attracting the interests of the research and regulatory communities. However, with the high cost and complex safety and logistical issues associated with field explosives testing, North American blast-resistant construction standards (e.g. ASCE 59-11 and CSA S850-12) recommend the use of shock tubes to simulate blast loads and evaluate relevant structural response. This study first aims at developing a simplified two-dimensional axisymmetric shock tube model, implemented in ANSYS Fluent, a computational fluid dynamics software, and then validating the model using the classical Sod’s shock tube problem solution, as well as available shock tube experimental test results. Subsequently, the developed model is compared to a more complex three-dimensional model and the results show that there is negligible difference between the two models for axisymmetric shock tube performance simulation; however, the three-dimensional model is necessary to simulate non-axisymmetric shock tubes. Following the model validation, extensive analyses are performed to evaluate the influences of shock tube design parameters (e.g. the driver section pressure and length and the expansion section length) on blast wave characteristics to facilitate a shock tube design that would generate shock waves similar to those experienced by civil infrastructure components under blast loads. The results show that the peak reflected pressure increases as the driver pressure increases, while a decrease in the expansion length increases the peak reflected pressure. In addition, the positive phase duration increases as both the driver length and expansion length are increased. Finally, the developed two-dimensional axisymmetric model is used to optimize the dimensions of a physical large-scale conical shock tube system constructed for civil infrastructure component blast response evaluation applications. The capabilities of such shock tube system are further investigated by correlating its design parameters to a range of explosion threats identified by different hemispherical TNT charge weight and distance scenarios.

Numerical Investigation of a New Structural Configuration of a Concrete Barrier Wall under the Effect of Blast Loads

Response of a New Structural Ultra-High Performance Concrete Barrier Wall Subjected to Blast Loading

Behaviour Of Ultra-High-Performance Concrete Barrier Walls Subjected To Blast Loading

Numerical Simulation of Blast Loads and Dynamic Response of Reinforced Concrete Slab Subjected to Close-in Explosion

The Numerical Investigation of Aluminum Foam-protected Reinforced Concrete Slabs under Blast Loading Using AUTODYN-3D

Validation study on numerical simulation of RC response to close-in blast with a fully coupled model

Evaluating concrete material models for blast analysis using 3D finite element analysis

Numerical analysis of reinforced concrete buildings subjected to blast load

Simulation of Reinforced Concrete Blast Wall Subjected To Air Blast Loading

Damage Mechanism Of Reinforced Concrete Slab Under Internal Blast Loading

Influence of Reinforcement and Attack Angle on the Destruction of a Concrete Barrier Under a High-Speed Impact

Blast performance of RC columns with different levels of concrete grades and reinforcing ratios

Numerical simulation of blast resistance of reinforced concrete slabs under fire conditions

Dynamic Structural Assessment of Blast Wall Designs on Military-Based Vehicle Using Explicit Finite Element Approach

Experiment and Numerical Investigations of Ultra-High Toughness Cementitious Composite Slabs under Contact Explosions

Experimental Investigation and Numerical Simulation on the Blast Resistance of Reactive Powder Concrete Subjected to Blast by Embedded Explosive

Numerical investigation on the behaviour of concrete barriers subjected to vehicle impacts using modified K&C material model

Blast-Resistance and Damage Evaluation of Concrete Gravity Dam Exposed to Underwater Explosion: Considering the Initial Stress Field

Blast load simulation using conical shock tube systems

Experimental and Numerical Investigations on Ultra-High Toughness Cementitious Composite Slabs Subjected to Close-in Blast Loadings

The effect of an explosive shock wave on the plate of a protective structure of a critical infrastructure