Abstract:Foam stability is adversely affected by the drainage process in the liquid film, which has been a great challenge for CO 2 foam flooding in applications. The Gibbs-Marangoni effect, which is induced by the interfacial tension (IFT) gradient, provides a resisting force to the thinning of liquid films in foams under disturbance. Surfactants with higher interfacial elasticity enable rapid recovery to the equilibrium state, thereby improving the stability of the CO 2 foam film. However, there is a lack of mechanistic studies aimed at elucidating the correlation between the interfacial elasticity of surfactant monolayers and the molecular structure of surfactants. In this paper, molecular dynamics simulations were employed to investigate the impact of the headgroups and linking groups of sodium polyoxyethylene alkyl ether sulfate (AES), sodium dodecylbenzene sulfonate (SDBS), sodium dodecyl sulfate (SDS), sodium dodecyl sulfonate (SDSn), and sodium laurate (SLA) surfactants on the interfacial morphology, monolayer properties, and surfactant behaviors at the CO 2 –water interface under reservoir conditions. The results show that the capacity to enhance CO 2 foam stability follows the order AES > SDS > SDSn > SDBS > SLA, which is in good agreement with the available experiments. AES monolayers can reach the lowest IFT (∼0.2 mN/m) and the highest interfacial elasticity (30.4 mN/m). We show that the ethylene oxide groups (EO chains) can strongly interact with water molecules via hydrogen bonding and have affinity interactions with CO 2 molecules, which is beneficial to the hydrophilic-CO 2 -philic balance (HCB). SDS monolayers show the second-lowest IFT (3.1 mN/m) and second-highest interfacial elasticity (26.0 mN/m). The linking oxygen atom in SDS facilitates bond rotation and is favorable to film stability. The phenyl group makes SDBS molecules too rigid and has poor HCB, leading to low stability with high IFT (16.0 mN/m) and low interfacial elasticity (13.1 mN/m). SLA has the highest IFT (22.1 mN/m) and lowest interfacial elasticity (6.3 mN/m), and also presents strong aggregation behaviors at the interface owing to interactions between the carboxyl groups. The simulation method and the microscopic insights delivered here are of great significance in screening surfactants to improve CO 2 foam performance in oilfields.

Effect of Interfacial Properties on the Stability of Ultra-Dry CO2-in-water (C/W) Foams Stabilized with Zwitterionic Surfactants and Nonionic/anionic Polymers: Experimental and DPD Simulation

Stabilization of Pickering Foams by High-Aspect-Ratio Nano-Sheets

Molecular Dynamics Simulation of the Synergistic Effect of Alkali/Surfactant/Polymer on the Formation and Stabilization of Water-Based Foam Systems

Interfacial properties and foam performance of alpha olefin sulfonate and CO2 switchable aminopropyl methyl siloxane surfactant mixtures

Stability mechanism of controlled acid-resistant hydrophobic polymer nanospheres on CO 2 foam

The CO2-in-water foam stabilized with the mixture of CO2-soluble surfactant and nonionic surfactant

CO2/N2 switchable aqueous foam stabilized by SDS/C12A surfactants: Experimental and molecular simulation studies

Structural basis for chemotherapeutic action of antiestrogens.

On the mechanism of enhanced foam stability by combining carboxylated cellulose nanofiber with hydrocarbon and fluorocarbon surfactants

Improvement of Foaming Ability of Surfactant Solutions by Water-Soluble Polymers: Experiment and Molecular Dynamics Simulation

Evaluation of the interfacial elasticity of surfactant monolayer at the CO 2 –water interface by molecular dynamics simulation: Screening surfactants to enhance the CO 2 foam stability

Effect of mixed surfactants on foam stabilization: A molecular dynamics simulation

Molecular dynamics simulation of the influence of polyacrylamide on the stability of sodium dodecyl sulfate foam

Design of nanoparticles for generation and stabilization of CO2-in-brine foams with or without added surfactants

Foaming Behavior of Polymer-Coated Colloids: The Need for Thick Liquid Films

Molecular dynamics simulation of the synergistic effect of a compound surfactant on the stability of CO2 oil‐based foam

Preparation of styrene‐phenylamine monomer copolymer nanospheres and its performance for stabilizing CO2 foam

Gas-liquid interface properties of fluorocarbon and hydrocarbon surfactants and their mixed foams: Molecular dynamics simulations and experimental studies

Investigations on the Influencing Mechanisms of SiO 2 Nanoparticles on Foam Stability

Stability and rheological properties of firefighting foams with sodium carboxymethyl cellulose and hydrocarbon/silicone surfactants

A Novel Supercritical CO2 Foam System Stabilized With a Mixture of Zwitterionic Surfactant and Silica Nanoparticles for Enhanced Oil Recovery