Abstract:Electrochemical co-deposition is a highly effective approach for achieving composites with specific composition and homogeneous distribution of reinforcement by manipulating electrolysis parameters. In this study, laminated carbon nanotubes reinforced copper composites (CNTs/Cu) were prepared through co-deposition and subsequent spark plasma sintering (SPS). In contrast to conventional powder metallurgy, the co-deposition method enables simultaneous deposition of CNTs and Cu particles while preserving the structural integrity of CNTs. It was observed that the CNTs were embedded within the growing Cu grains, resulting in a tightly bonded interface between them. The content of CNTs in composite deposited under current density of 0.5, 1.0 and 1.5 A & sdot;dm-2 is measured to be 0.51 vol%, 1.05 vol% and 1.31 vol%, respectively. The average grain size exhibited a significant reduction, decreasing from approximately 33.4 mu m for pure Cu to 3.3 mu m for the CNTs/Cu composite deposited under current density of 1.5 A & sdot;dm-2. Compared to pure Cu, the composite exhibited a significantly enhanced yield strength of 254 MPa, which is approximately 5 times that of pure Cu, the ultimate tensile strength improved to 290 MPa with an elongation of 15%, and the strengthening efficiency was calculated to be as high as 476. Load transfer is the primary contribution to the strength of the composites, followed by an increase in dislocation density and grain refinement. Meanwhile, the electrical conductivity of the composite with optimized condition demonstrated a high value of 94.4% IACS. The co-deposition method can facilitate the homogeneous dispersion of CNTs, enhance interfacial bonding, improve the structural integrity of CNTs, thereby enabling synergistic optimization of the properties of laminated CNTs/Cu composites.

Fabrication of CNTs Reinforced Copper Composite Powders by Electrochemical Co-Deposition

Electrodeposition and Properties of Composites Consisting of Carbon Nanotubes and Copper

Synergistic Optimization of Properties in Carbon Nanotubes Reinforced Cu Matrix Composites Prepared by Co-Deposition

The Influence of Electro-Deposition Parameters on Conductivity and Morphology of Structurally Uniform MWCNTs/Cu Composite Films

Preparation of CNTs/Cu Composites with Good Electrical Conductivity and Excellent Mechanical Properties

Fabrication and Densification of High Performance Carbon Nanotube/copper Composite Fibers

Progress of CNTs Reinforced Copper-based Composite Preparation

Novel Synthesizing and Characterization of Copper Matrix Composites Reinforced with Carbon Nanotubes

Fabrication of Copper Matrix Composites Reinforced with Carbon Nanotubes Using an Innovational Self-Reduction Molecular-Level-Mixing Method

An Electroless Deposition Strategy for Preparing Ultrathin CNTs/Cu Composite Foils with Excellent Mechanical Properties

Simple and Efficient Preparation of Uniformly Dispersed Carbon Nanotubes Reinforced Copper Matrix Composite Powders by in Situ Chemical Vapor Deposition Without Additional Catalyst

Improvement of interfacial interaction and mechanical properties in copper matrix composites reinforced with copper coated carbon nanotubes

Preparation of copper matrix carbon nanotube composite films

Enhancing the Strength of Carbon Nanotubes Reinforced Copper Matrix Composites by Optimizing the Interface Structure and Dispersion Uniformity

Fabrication, Mechanical Properties and Electrical Conductivity of Al2O3 Reinforced Cu/CNTs Composites

Fabrication of CNTs/Cu ultrafine powders and composite materials

Synthesis and Properties of Surface-Modified Carbon Nanotube/Copper Composites

Electroless Deposition of Cu on Multiwalled Carbon Nanotubes

Preparation of CNTs/Cu Composite

Preparation of Ultra-thin sandwich Cu-Cu/CNTs-Cu Composite Foil with High Tensile Strength by Electrodeposition

Improving comprehensive performance of copper matrix composite by spray pyrolysis fabricated CNT/W reinforcement