Abstract:As one of the most traditional vibration mitigation devices, tuned mass dampers (TMDs) are applied widely in aseismic protection of building structures. The control effect of a passive TMD is depended on its parameters, especially the frequency ratio. Nevertheless, passive TMDs are high sensitive to the frequency detuning issue, and a mistuned TMD will lose its aseismic protection. Soil-structure interaction (SSI) will deviate the structural frequency and lead to a mistuned TMD. Besides, different soil conditions will lead to different frequency deviations of the primary structure. However, it may be difficult to obtain parameters of the soil exactly. To solve this problem, a recently developed adaptive-passive eddy current pendulum TMD (APEC-PTMD) is applied to a benchmark 40-story tall building including SSI in this study, and four different soil conditions are considered. The APEC-PTMD can identify the optimal TMD frequency in the building with different soil types, and then retune itself through adjusting the pendulum length, and also the air gap between the conduct plate and permanent magnets to reset its damping ratio. Therefore, no prior knowledge of the soil condition is needed for the APEC-PTMD. To verify the aseismic protection effect, 44 far-field earthquake excitations are chosen, and two passive TMDs are used for comparison, while one is optimized for the base-fixed structure and the other is optimized based on the dense-soil model. The passive TMD will become mistuned when SSI is considered or soil parameters are changed, while APEC-PTMD can adapt to the structural dominant frequency with different SSI. Therefore, it always works as a passive TMD with well-tuned parameters. Results show that the APEC-PTMD has a better aseismic protection than the passive TMD, especially in the soft-soil model, and it has an excellent control effect compared to the without TMD case at the same time.

Study on adaptive-passive multiple tuned mass damper with variable mass for a large-span floor structure

Experimental Study on Adaptive-Passive Tuned Mass Damper with Variable Stiffness for Vertical Human-Induced Vibration Control

Study on Self‐adjustable Variable Pendulum Tuned Mass Damper

An adaptive‐passive retuning device for a pendulum tuned mass damper considering mass uncertainty and optimum frequency

Study on Adaptive-Passive Eddy Current Pendulum Tuned Mass Damper for Wind-Induced Vibration Control

Design and Analysis on Vibration Control of Long-Span Floor Structures

Adaptive-passive Tuned Mass Damper for Structural Aseismic Protection Including Soil–structure Interaction

Fundamental characteristics study of multiple tuned mass damper (MTMD) in control of structure vibration

Mitigation of wind response of a tall building using semi‐active tuned mass dampers

Optimization of Multiple Tuned Mass Dampers for Large-Span Roof Structures Subjected to Wind Loads

A Novel Assembled Pendulum-Type ATMD for Structural Vibration Control

Pedestrian- and Wind-Induced Bi-Directional Compound Vibration Control Using Multiple Adaptive-Passive TMD-TLD System

Study on Adaptive-Passive and Semi-Active Eddy Current Tuned Mass Damper with Variable Damping

Design and Application of Double-Parallelograms-based Tuned Mass Damper for Low-Frequency Vibration Absorption

Multiple Tuned Mass Dampers for Wind Induced Vibration Control of a Cable-Supported Roof

Floor vibration control considering human-structure interaction

A Passive Adaptive Suspended Mass Pendulum to Compensate Detuning Due to Large Swing Angle

Parameters Optimization and Performance Evaluation of Multiple Tuned Mass Dampers to Mitigate the Vortex-Induced Vibration of a Long-Span Bridge

Investigations on Serviceability Control of Long-Span Structures under Human-Induced Excitation

Evaluation of Multiple Active Lever-Type Tuned Mass Dampers for Structures under Ground Acceleration

Study on the Application of Large Tuned Mass Ratio in Damping System