Abstract:The rotor conductor bars of the line-start synchronous reluctance motor (LS-SynRM) make the motor have self-starting capability. The distribution of the rotor conductor bars not only has a great impact on the starting capability, but also affects the steady-state performance of the LS-SynRM. The steady-state performance of the LS-SynRM mainly depends on the inductance parameters. And the distribution of the rotor conductor bars directly affects the variation of the inductance parameters, especially the d-axis inductance. Based on the steady-state characteristics of LS-SynRM, an evaluation method based on finite element analysis (FEA) is proposed to determine whether the rotor conductor bars of LS-SynRM is reasonable. First, the d-axis inductance reference model without rotor conductor bars is established, the target of optimize is to reduce the weakening effect of rotor conductor bars on the d-axis inductance, and the optimal distribution structure of rotor conductor bars is determined. The optimization results show that the d-axis inductance of the determined rotor conductor bars structure in this article reaches 96.2% of the reference inductance and the distribution of the rotor bars achieves better results. It is verified that the improved LS-SynRM has better efficiency, starting capability, and maximum torque than the initial LS-SynRM by FEA and prototype test. At the same time, comparing with the performance of the three-phase squirrel cage induction motor for compressor, it is proved that the improved LS-SynRM has higher efficiency and a good application prospect.

Research on the Improvement of Load Capacity of LCI-Fed Synchronous Motor by Constant Commutation Margin Angle Control

Research on Soft Starting Control Strategy for LCI-fed Synchronous Motor

Soft Start Control of Large-Capacity Synchronous Motor

An I/f Control Method With Closed-loop Regulation of Current Vector for Surface Permanent Magnet Synchronous Motor Drives

Reasearch on Sensorless PM Brushless DC Motor Starting Control

Research of V/f Control Method for Multiphase Induction Motor with Non-sinusoidal Supply at Low Speed

Sensorless control and start-up strategy of permanent magnet synchronous motor

A high efficiency direct instantaneous torque control of SRM using commutation angles control

Research on Identification of Inertia for LCI-fed Synchronous Motor

High-Power-Factor Control Of Ipmsm Drive System With Small Dc-Link Capacitor

A High Efficiency Torque Control Method of Switched Reluctance Motors Using Low Loss Commutation Control

Research on Energy Feedback Control of Synchronous Motor Driven by Load Commutated Inverter

Study on the Influence of Design and Optimization of Rotor Bars on Parameters of a Line-Start Synchronous Reluctance Motor

Modeling and Optimization of Soft Start-Up for Hydroviscous Drive Applied to Scraper Conveyor

An Optimized Start-up Switching Strategy of Sensorless Control of PMSM

The weighted synergetic speed control for single inverter, parallel-connected induction motor drive

Research on System of Self-Controlled Soft Start with Variable Frequency for Synchronous Motor

Current-coordinated Control of Electrically Excited Synchronous Motor and Steady State Analysis

Research and Simulation of SCR Soft-Start Asynchronous Motor

Starting Control of Three-stage Synchronous Motor Based on Improved Current-coordinated Vector Control

Rotor Design and Optimization of a Three-Phase Line-Start Synchronous Reluctance Motor