Abstract:Multiphase machines are very essential for industrial applications that require high reliability of operation. In this paper, a comparative study of three-phase and five-phase inverter fed permanent magnet synchronous motors (PMSMs) was evaluated with respect to their performance characteristics under a healthy state and during transient disturbances such as varied load and double line to ground faults. To avert inherent high oscillations in speed and torque ripples during fault condition, the machine load was significantly reduced to 1/4th of the full load and a post fault current limiting series dynamic braking resistance (SDBR) with a bypassed switch was introduced to enhance the machine fault tolerant level and improve its operational performance. Spectral analyses were carried out to determine the magnitude of harmonic distortion during these conditions. The simulation results show that the five-phase PMSM achieved a reduced oscillatory transient and a faster settling time of speed and torque under a varied load. It also exhibited good harmonic profiles as indicated in the respective % THD values when compared to the three phase PMSM which is prone to high harmonic overheat. However, when subjected to a double line to ground fault, their various %THD values in speed and torque increased with five-phase PMSM still having a reduced %THD values over the three-phase PMSM. Therefore, for a higher fault tolerant capability, greater efficiency with proven reliability, a five-phase PMSM with a fault current limiting series dynamic braking resistance is a better substitute when compared with the three-phase PMSM in industrial applications where safety and loss minimization is a top priority. All simulation processes in this paper were achieved in MATLAB 2015.

Comparison Of Five-Phase And Three-Phase Pmsms With Identical Silicon Steel Laminations

Comparison of Dual-Stator Permanent Magnet Machines with Different Rotor Topologies

Electromagnetic Performance Comparison of Doubly Salient PM Machines with Different Stator Iron Core Segments

Fault-Tolerance Performance Analysis of a Five-Phase Permanent-Magnet Linear Synchronous Machine

A Consequent-Pole Five-Phase Fault-Tolerant Permanent-Magnet Synchronous Machine for Electric Vehicles

A five-phase 20-slot/18-pole PMSM for electric vehicles

Research on a five-phase in-wheel permanent-magnet synchronous machine

Investigation of a five-phase 20-slot/18-pole PMSM for electric vehicles

Research on a 20-Slot/22-Pole Five-Phase Fault-Tolerant PMSM Used for Four-Wheel-Drive Electric Vehicles

Comparison of PMSMs with Different Rotor Structures for EV Application

Research on a four-phase fault-tolerant PMSM used for EVs

A Novel Five-Phase Fault-Tolerant Modular In-Wheel Permanent-Magnet Synchronous Machine For Electric Vehicles

Evaluative assessment of a five-phase and three-phase permanent magnet synchronous machine at varied loads and fault conditions

Investigation of a five-phase 30-slot/32-pole in-wheel outer-rotor permanent-magnet synchronous machine for electric vehicles

Quantitative Comparison of Partitioned-Stator Machines for Hybrid Electric Vehicles

Analysis and design of a fault-tolerant six-phase permanent-magnet synchronous machine for electric vehicles

A Comparative Study on Two Outer Rotor PMSMs for In-Wheel Direct Drive under Short-Circuit Faults

Comparative Study of Winding Configurations of a Five-Phase Flux-Switching PM Machine

Analysis, design and prototyping of a low-speed high-torque six- phase fault-tolerant permanent magnet synchronous machine for EVs

Optimal design of a five-phase outer-rotor permanent-magnet synchronous machine

Comparative Study Between Doubly Salient PM Machine with New Stator/Rotor-Pole Number Combination and Biased Flux PM Machine