Abstract:With the shrinkage of chip size and the increase of integration density, chip heat flux increases dramatically. Efficient heat dissipation becomes critical for the performance, reliability and service life of electronics. Therefore, advanced lateral heat spreader materials such as carbon allotropes and their derivatives are highly desirable in modern electronics. Graphene attracts great attention as a lateral heat spreader material due to its unique thermal transfer property (theoretical thermal conductivity ca. 5300 W m -1 K -1 ) and its natural two-dimensional (2D) structure. However, an efficient method to accomplish large scale production and ordered assembly structures of graphene sheets is critical for real application in heat dissipation in electronics. Conventional production methods to produce graphene sheets such as filtration method, solvent evaporation method, chemical vapor deposition, electrostatic spray deposition etc. have some limitations-long production time, high energy consumption and great difficulties in controlling the sheet geometry, for instance. In this contribution, graphene sheets were fabricated by a wet-spinning method of graphene oxide (GO) solution followed by chemical reduction of GO to reduced graphene oxide (rGO). The wet-spinning method was able to produce graphene sheets in a high rate (~1.2 m/min) and in different dimensions. Here sheets with different thickness (8 μm and 16 μm) are demonstrated. A series of characterizations are performed for the produced GO and rGO sheets including their Raman and infrared spectra, X-ray diffraction pattern, scanning microscopic pictures and atomic force microscopic pictures. These data show that the reduction is sufficient and the GO sheets are piled up parallel during the wet-spinning process, which is beneficial for the lateral heat transport. The rGO has an in-plane electrical conductivity ca. 6848.41 S/m and thermal conductivity ca. 1024.86 W m -1 K -1 . In addition, the film displayed excellent heat dissipation performance when attached on top of a light emitting diode (LED) light strip. The research results indicate our approach is facile and capable of fabricating scalable and controllable heat spreader materials with high performance.

A Lightweight and High Thermal Performance Graphene Heat Pipe

A light-weight and high thermal performance graphene heat pipe

Remarkable Thermal Performance Enhancement of Micro Heat Pipes with Graphene-Nanoplatelet Nano-Wicks

Ultra-efficient Heat Pipes Enabled by Nickel-Graphene Nanocomposite Coatings: Concept and Fundamentals

Performance Enhancement of Graphene-Coated Micro Heat Pipes for Light-Emitting Diode Cooling

Study of Heat Dissipation Characteristics of Loop Heat Pipe with Heat Sink of Composite Material

Anomalously enhanced thermal performance of micro heat pipes coated with heterogeneous superwettable graphene nanostructures

Lightweight All Graphene‐Based Two‐Phase Heat Transport Devices

High Performance Copper-Water Heat Pipes with Nanoengineered Evaporator Sections

Enhanced Heat Dissipation for Macroscopic Metals Achieved by a Single-Layer Graphene

Theoretical Model to Investigate the Heat Transfer Mechanism through a Heat Pipe with Graphene Oxide/Distilled Water as Working Fluid

Biomimetic Copper Forest Wick Enables High Thermal Conductivity Ultrathin Heat Pipe

Experimental Studies on a Novel Thin Flat Heat Pipe Heat Spreader

Lightweight Thermal Interface Materials Based on Hierarchically Structured Graphene Paper with Superior Through-Plane Thermal Conductivity

Significant enhancement of metal heat dissipation from mechanically exfoliated graphene nanosheets through thermal radiation effect

Characteristics of thermal storage heat pipe charged with graphene nanoplatelets enhanced organic phase change material

Experimental investigation on a 0.5-metre-long aluminum flat heat pipe for thermal management in electronic devices

Wet-spun Graphene Sheets As Flexible Heat Spreaders for Efficient Thermal Management

Research on the Heat Dissipation in Aviation-Integrated Communication Equipment Based on Graphene Films

Thermal Characteristic of a Novel Flat Plate Heat Pipe for Hybrid Integrated Power Electronic Module

Flexible heat pipes with integrated bioinspired design