Hybrid Force/Position Control for Switchable Unmanned Aerial Manipulator Between Free Flight and Contact Operation
Zhenguo Zhang,Yanjie Chen,Yangning Wu,Bingwei He,Zhiqiang Miao,Hui Zhang,Yaonan Wang
DOI: https://doi.org/10.1109/tase.2023.3294254
IF: 6.636
2023-01-01
IEEE Transactions on Automation Science and Engineering
Abstract:The refined aerial operations of the unmanned aerial manipulator (UAM) have been extensively studied for the last decades. Usually, UAM operations are accompanied by several phases, such as free flight, contact operations, and separation. A great challenge is proposed for switching operations in different environments and the high-precision contact force requirements of UAM control, so this paper conducts control stability research in the case of dynamic differences between free flight and contact operation for the UAM system. First, a hybrid force/position control strategy is proposed for switchable UAM system, among them, the adaptive sliding mode control method based on the interference observer is utilized in the free flight phase, and the adaptive impedance force control method is employed in the contact operation phase, where the adaptive estimation method is designed to perform on-board manipulator contact force estimation. Then a robust adaptive control strategy is proposed for the attitude loop to compensate for the torque disturbance generated during the contact operation phase. Meanwhile, the stability of the switching system is analyzed through the continuous Lyapunov function to prove the stability of the switching process. Finally, the effectiveness and superiority of the proposed schemes are verified through contact operation simulations and experiments. Note to Practitioners-This work is motivated by the contact force tracking of an UAM without force sensor. In recent years, hybrid force/position control has been widely used in UAM. However, force measurement is required at the end-effector and the object in most studies. The proposed method divides the contact operation process into free flight and contact operation stages. In the free flight stage, it is not necessary to know the prior information of the environment accurately (i.e. the external disturbance of slowly varying or known upper bound), and the disturbance observer is adopted to compensate for the disturbance caused by the external environment. In the contact operation stage, the impedance force control method is used for force tracking, which reduces the complexity and quality of the end-effector. At the same time, The shock caused by the switch from free flight to contact operation is reduced by calculating the appropriate controller parameters using the Lyapunov function. The proposed method is a promising solution for real applications and is validated via simulation and indoor contact experiments. The experimental results show that the proposed method has better stability and accuracy than the existing methods, and can be extended to industrial inspection, component processing, aerial operation, etc.