Abstract:The energy harvesting backpack is a promising solution for powering wearable electronic devices by converting biomechanical energy from human motion into electricity. However, the majority of current energy harvesting backpack models primarily focus on harvester dynamics while neglecting the crucial role of humans as an energy source in the system. Some studies have utilized inverted pendulum models through active control torque and optimization-based methods to investigate human factors in bioenergy harvesting systems, but this is complex for the practical application of biomechanical models. To overcome these issues, a new biomechanical model of the energy harvesting backpack is proposed in this paper. The contribution of this study is not only modeling the cooperative dynamics between backpacks and humans which is easily solvable and comprehensible but also defining multi-indicators for model verification and backpack evaluation. The biomechanical model without load is established based on the D' Alembert principle and empirical gait phase division of 3:1 when it is assumed that the gait parameters remain constant regardless of the load being carried. Four sets of data from two distinct databases are utilized to analyze the dynamics of the bipedal walking model in both vertical and horizontal directions. The biomechanical model with energy harvesting backpacks is proposed to define four single direct indicators and two global indirect indicators for demonstrating the proposed model’s ability to predict the characteristics of backpacks. Finally, the foot-reaction force, the vibration of the center of mass, and the output power of three subjects are acquired in five experiments (i) with no backpack under variable walking speed; (ii) an ordinary backpack under variable walking speed; (iii) an ordinary backpack under variable loads; (iv) an energy harvesting backpack under variable walking speed; and (v) an energy harvesting backpack under variable loads. The comparison between the proposed model and experimental results demonstrates that the proposed model is easy to solve and comprehend, and can effectively capture the characteristics of both human and energy harvesting backpacks.

Design of an Elastically Suspended Backpack with a Tunable Damper

A simple model for predicting walking energetics with elastically-suspended backpack.

Development of a Novel Elastic Load-Carrying Device: Design, Modeling and Analysis

Energy Performance Analysis of a Suspended Backpack with an Optimally Controlled Variable Damper for Human Load Carriage

Design and Investigation of a Suspended Backpack With Wide-Range Variable Stiffness Suspension for Reducing Energetic Cost

Energetic Response of Human Walking with Loads Using Suspended Backpacks

Nonlinear stiffness mechanism designed by topology optimization reduces backpack vibration

Power Backpack for Energy Harvesting and Reduced Load Impact

Load-suspended power backpack for labor saving and energy harvesting from human walk

An Ergonomics Evaluation of the Vibration Backpack Harness System in Walking

Design and Experiment Evaluation of a Magneto-Rheological Damper for the Legged Robot.

Allowing the Load to Swing Reduces the Mechanical Energy of the Stance Leg and Improves the Lateral Stability of Human Walking

Design of a Semiactive TMD for Lightweight Pedestrian Structures Considering Human–Structure–Actuator Interaction

[The Effects of Backpack Loading on the Gait and Corresponding Compensatory Strategy].

Magnetorheological Damper With Variable Displacement Permanent Magnet for Assisting the Transfer of Load in Lower Limb Exoskeleton

Mechanical design of a passive lower-limb exoskeleton for load-carrying assistance

Biomechanical modeling and experiments of energy harvesting backpacks

Research on Mechanical Leg Structure Design and Control System of Lower Limb Exoskeleton Rehabilitation Robot Based on Magnetorheological Variable Stiffness and Damping Actuator

Design and analysis of plantar hydraulic control device for body weight support treadmill training

Enhance the energy dissipation ability of sleeve-type negative stiffness structures via a phase-difference mechanism

A Novel Design of Unpowered Exoskeleton for Loaded Walking Using Only Hip Abduction Torque