Direct biohydrogen production from chitosan harvested microalgae biomass and an isolated yeast

Jessica K. Suastes-Rivas,María José Romero-Pineda,Ignacio Monje-Ramírez,Sharon B. Velasquez-Orta,Antonio Velasco,María Teresa Orta-Ledesma

DOI: https://doi.org/10.1016/j.enconman.2024.118081

IF: 10.4

2024-01-28

Energy Conversion and Management

Abstract:There is a bottleneck in recovery microalgae biomass from cultivations to recovery bioenergy the low metabolites yields achieved still lacks low operating cost. Optimization of the harvesting process such as coagulation-flocculation is crucial to find the conditions of a chemical compound for biomass and metabolites recovery and suitable or easy assimilation by microorganism for biohydrogen production. Dose, pH, flocculation velocity, flocculation and settling times are relevant factors that influence over biomass and metabolites recovery and define the requirements of the harvesting process in terms of invested energy. The aim of this study is to get the efficiency of biomass and biomolecules separation by using the response surface methodology for three chemical compounds such as ferric chloride, aluminum sulfate and chitosan. The design presented recovery efficiencies highest as 99 % for all the coagulants. A selection of coagulant conditions yields augmentation a carbohydrates content subsequently transformed to biohydrogen. The mix of microalgae and chitosan presented high carbohydrates increase or a low effect on carbohydrates determination in comparison to those harvested using other flocculants, where the microalgae biomass was washed because of precipitates formation. The biohydrogen produced from untreated harvested microalgae biomass with chitosan was of 1.958 ± 0.2 mmol/L using isolated indigenous yeast Candida sp. by using the chitosan concentration to recovery the maximum biomass concentration (0.02 g/L), was of 2.4 ± 0.1 mmol/L of H 2 . Under these conditions, the energy reduction was from 0.15 kWh/m 3 to 1.2 kWh/m 3 , 35 % to >80 % less in comparison with other flocculants applied. In this context, the findings demonstrated that applying an organic flocculant for microalgae harvesting even lacking high biomass and carbohydrates yields, the biomass can be enriched and improved leading for a sustainable and direct route to produce a potential biofuel.

energy & fuels,thermodynamics,mechanics