Using Activated Peroxymonosulfate by Electrochemically Generated FeII for Conditioning and Dewatering of Anaerobically Digested Sludge

Min Yang,B. Hasaer,Yaohui Bai,Ruiping Liu,Chengzhi Hu,Jiuhui Qu
DOI: https://doi.org/10.1016/j.cej.2019.123603
IF: 15.1
2020-01-01
Chemical Engineering Journal
Abstract:To avoid the unfavorable SO4-center dot consumption by excessive Fe-II in traditional Fe-II-activated peroxymonosulfate (PMS) system, this study investigates the conditioning performance of the electrochemical-Fe-II activated PMS, i.e., E-Fe-II-PMS, towards anaerobically digested sludge (ADS) by comparing with chemical-Fe-II activated PMS (C-Fe-II-PMS). At equilibrium pH of 6.0, the capillary suction time (CST) of raw ADS was decreased by 51.2% for C-Fe-II-PMS and 67.6% for E-Fe-II-PMS with the same total Fe-II dose of 25 mg/g DS. E-Fe-II-PMS is more efficient to degrade EPS and damage cells, and thus improves the release of bound water and intracellular water greatly. The cell viability ratios remarkably decreases from 71.8% for raw ADS to 22.6% for C-Fe-II-PMS and 10.1% for E-Fe-II-PMS. Moreover, E-Fe-II-PMS significantly reduces the total PN contents to 41.9% and the total PS contents to 43.8% for EPS fraction. The Fe2+ concentrations in supernatant was determined to be 191.3 mg/L for C-Fe-II-PMS and much lower of 36.9 mg/L for E-Fe-II-PMS after 15 min reaction, and the continuous introduction of Fe-II in E-Fe-II-PMS achieves stable Fe2+ concentrations and minimizes SO4-center dot consumption by the excessive Fe-II in C-Fe-II-PMS as much as possible. Otherwise, Fe-III-Fe-II cycling at cathode side also increases Fe-II utilization.
What problem does this paper attempt to address?