Abstract:For advanced aircraft, the temperature environment inside the cabin is very severe due to the high flight speed and the compact concentration of the electronic equipment in the cabin. Accurately predicting the temperature environment induced inside the cabin during the flight of the aircraft can determine the temperature environment requirements of the onboard equipment inside the cabin and provide an accurate input for the thermal design optimization and test verification of the equipment. The temperature environment of the whole aircraft is divided into zones by the cluster analysis method; the heat transfer mechanism of the aircraft cabin is analyzed for the target area; and the influence of internal and external factors on the thermal environment is considered to establish the temperature environment prediction model of the target cabin. The coefficients of the equations in the model are parameterized to extract the long-term stable terms and trend change terms; with the help of the measured data of the flight state, the model coefficients are determined by a stepwise regression method; and the temperature value inside the aircraft cabin is the output by inputting parameters such as flight altitude, flight speed, and external temperature. The model validation results show that the established temperature environment prediction model can accurately predict the change curve of the cabin temperature during the flight of the aircraft, and the model has a good follow-up performance, which reduces the prediction error caused by the temperature hysteresis effect. For an aircraft, the estimated error is 2.8 °C at a confidence level of 95%. Engineering cases show that the application of this method can increase the thermal design requirements of the airborne equipment by 15 °C, increase the low-temperature test conditions by 17 °C, and avoid the problems caused by an insufficient design and over-testing. This method can accurately predict the internal temperature distribution of the cabin during the flight state of the aircraft, help designers determine the thermal design requirements of the airborne equipment, modify the thermal design and temperature test profile, and improve the environmental worth of the equipment.

Multi-factor Coupled Heat Transfer Model with Multi-layer and Dynamic Heat Transfer Characteristics in Vehicle Cabin

Simulation, Experimentation, and Collaborative Analysis of Adjacent Heat Exchange Modules in a Vehicular Cooling System

A Study on Heat Transfer Model for the Dynamic Contact Boundary Between Piston Ring and Cylinder Liner

More intelligent and efficient thermal environment management: A hybrid model for occupant-centric thermal comfort monitoring in vehicle cabins

Thermal comfort study of occupant compartment under multi-temperature zone coupling

A Study of Passenger Car Cabin Pre-Ventilation under the Sun

Simulation and Experimental Study on Thermal State of Engine Compartment of Commercial Vehicle

Calculation Model and Numerical Simulation of Cabin Thermal Environment

A Research on the Heat Transfer Characteristics and Temperature Field Change of Vehicle Internal and External Surfaces During Ageing Test

Experimental and Numerical Study of Air Flow and Temperature Variations in an Electric Vehicle Cabin During Cooling and Heating

Uniform segment-wise body parametric convection heat transfer coefficient model for sitting posture in vehicles

Simulation Model and Verification of Heat Transfer Characteristics in Aircraft Cabin Bulkhead

The Dynamic Prediction Method for Aircraft Cabin Temperatures Based on Flight Test Data

Human Thermal Comfort Calculation of Cabin Thermal Environment

Analysis of Human Thermal Comfort in Bus Based on Thermoelectric Cooling Climate-Controlled Seats

Research on Automotive Seat Heating Strategy Based on Objective Thermal Comfort Evaluation

Research on the thermal comfort of passenger compartment based on the PMV/PPD

Experimental investigation of thermal comfort in a passenger car under driving conditions

Multi-scale Thermal Analysis Approach for the Typical Heat Exchanger in Automotive Cooling Systems

The influence of different orientations and ventilation cases on temperature distribution of the car cabin in the hot soak

Research on electric vehicle thermal management system with coupled temperature regulation between crew cabin and power battery pack