Abstract:Passengers usually experience complex thermal experience and metabolic rate changes in the departure process of high-speed railway stations. Previous studies did not consider the variations of passenger thermal comfort during the multiple spatial transitions with those simultaneous changes. Therefore, this study aims to investigate the dynamic thermal responses of passengers in the whole departure process as well as identify their specific thermal comfort demands in different functional zones. The behavior sequences of 17,354 passengers were investigated in a typical high-speed railway station. The obtained behavior characteristics were then replicated in a sequence of five climate chambers to simulate the spatial transition process, including outdoor entrance square, security check area, concourse, waiting room, and check-in area. The variations of passengers' thermal experience were designed with 24 temperature variation sequences using four different indoor temperature settings (24 °C, 26 °C, 28 °C, and 30 °C) and two outdoor environmental conditions of low-temperature conditions (LTCs) at 27–30 °C and high-temperature conditions (HTCs) at 32–35 °C. Thirty subjects dressed in 0.49 clo were recruited, and variations in their psychological and physiological responses were recorded throughout the experiments. The results showed that although the outdoor thermal experience resulted in passengers' subjective perceptions to the level of very uncomfortable, it also improved their thermal adaptive capacity in the waiting room and check-in area. The stabilized time of thermal comfort vote (TCV) (5.34–14.84 min) in the waiting room was shorter than that of thermal sensation vote (TSV) (13.36–18.23 min), and the time required for heart rate and skin temperature to reach stability there concentrated in 12–20 min and 16–20 min, respectively. Moreover, quantitative relationships between neutral temperature ( T n ) and specific influential factors were acquired for each functional zone. The variation ranges of T n in security check area, concourse, waiting room, and check-in area were 23.62–24.68 °C, 24.45–25.24 °C, 25.00–25.63 °C, and 24.88 °C in LTCs and 22.40–23.10 °C, 24.09–24.68 °C, 25.05–25.86 °C, and 24.56–25.38 °C in HTCs. The corresponding 90% acceptable temperature ranges varied from 1.28 °C to 3.06 °C. This study provides references for enhancing passenger thermal comfort and optimizing the indoor environments.

Thermal comfort study of occupant compartment under multi-temperature zone coupling

Effect of Inhabitant Behavioral Responses on Adaptive Thermal Comfort under Hot Summer and Cold Winter Climate in China

Experimental investigation of thermal comfort in a passenger car under driving conditions

More intelligent and efficient thermal environment management: A hybrid model for occupant-centric thermal comfort monitoring in vehicle cabins

Research on the thermal comfort of passenger compartment based on the PMV/PPD

Multi-factor Coupled Heat Transfer Model with Multi-layer and Dynamic Heat Transfer Characteristics in Vehicle Cabin

Study on Thermal Comfort of Vehicle Interior Environment Based on Thermal Manikin

Experimental Study on Dynamic Thermal Environment of Passenger Compartment Based on Thermal Evaluation Indexes.

Experimental study of group thermal comfort model

Studies of air-flow and temperature fields inside a passenger compartment for improving thermal comfort and saving energy. Part II: Simulation results and discussion

Research on Non-isothermal Jet Air Supply Method for Human Thermal Comfort Regulation in Commercial Vehicle Based on Localized Air Conditioning System

Studies of Air-Flow and Temperature Fields Inside a Passenger Compartment for Improving Thermal Comfort and Saving Energy. Part I: Test/numerical Model and Validation

Experimental Assessment of a Satisfaction Based Thermal Comfort Control for a Group of Occupants

Analysis of Human Thermal Comfort in Bus Based on Thermoelectric Cooling Climate-Controlled Seats

Human Thermal Comfort Calculation of Cabin Thermal Environment

Study on Local Thermal Sensation and Model Applicability in Vehicle Cabin under Different Driving States

Practical Application of Model Predictive Zonal Temperature Estimation and Control for Vehicle Cabins

Demand-oriented differentiated multi-zone thermal environment: Regulating air supply direction and velocity under stratum ventilation

Thermal Management Simulation and Study on the Vehicle Engine Room of a Sedan Based on STAR-CCM+

Implementation of 1d/3d Integrated Model for Cabin Thermal Comfort and Energy-Saving Potential in Electric Vehicle Transcritical Co2 Heat Pump Air Conditioning System

Passenger thermal comfort in the whole departure process of high-speed railway stations: A case study with thermal experience and metabolic rate changes in summer