Abstract:Abstract Design fatigue curves of new concept were developed in the Subcommittee on Design Fatigue Curve in the Atomic Energy Research Committee in the Japan Welding Engineering Society (JWES). Also, Working Group on Design Fatigue Curves (WG DFC) in the JSME is studying the validity and the applicability of the design fatigue curves developed in the JWES to incorporate into the JSME Environmental Fatigue Evaluation Method. The developed design fatigue curve consists of the best-fit curves using tensile strength as a parameter, correction of mean stress effect employed the Smith-Watson-Topper approach, surface finish effect and variable loading amplitude effect. This paper discusses the treatment of variable loading amplitude effect in the improved design fatigue curves. The developed design fatigue curves have employed the method of variable loading amplitude effect in EN 13445. This method uses a fatigue life exponent of −0.1 from N = 2 × 106. Research Group on Fatigue Strength in the JSME performed a series of fatigue tests for variable loading amplitude and the test data showed the fatigue life exponent was −0.07. This outcome of the JSME Research Group can support the fatigue life exponent of −0.1 in EN 13445. A survey of the procedure of variable loading effect has been performed on a thermal fluctuation transient at mixed zone of T-junction piping of nuclear power plants for which UF is significantly affected by variable loading effect. Based on this study, the design fatigue curve for variable loading effect that starts from 2 × 106 with the slope of 1/10, which comes from EN 13445-3, can be considered to be applicable to the developed design fatigue curves. Also, the difference of UF between up to 1 × 108 and extension with no limit is relatively small, and the maximum number of cycles of 1 × 108 can be employed for the engineering fatigue analysis.

Modification and Extension of Screening Criteria for Fatigue Analysis

A Simplified Fatigue Assessment Method for ASME VIII-2

A New Method for Studying the Effect of Multiaxial Strain States on Low Cycle Non-Proportional Fatigue Prediction

Simplified Fatigue Design Assessment (Fda) Procedure For Slots/Cut-Outs Based On A Stress Concentration Factor (Scf) Approach

Development of New Design Fatigue Curves in Japan – Treatment of Variable Loading Amplitude Effect

Application of various low cycle fatigue evaluation rules to notched compact tension specimen test data

Analysis of Recent Fatigue Data Using the Structural Stress Procedure in ASME Div 2 Rewrite

On Fatigue Design Curves for 2.25Cr-1Mo-v Steel Reactors at Elevated Temperature in Code Case 2605

Evaluation of Fatigue Crack Growth Curves in Existing Codes and A Proposed Modification Based on Experimental Data of Cr-Ni-Mo-V Steel Welded Joints

A Novel Fatigue Assessment Approach by Direct Steady Cycle Analysis (DSCA) Considering the Temperature-Dependent Strain Hardening Effect

The Structural Strain Method for Fatigue Evaluation of Welded Components: Analytical Treatment of Reversed Plasticity

Fatigue Failure Criterion of Materials with Static Constitutive Curve As the Limit Value

A New Two-parameter Multi-axial Fatigue Failure Criterion Based on Critical Plane Approach

Effective Fatigue Stress and Criterion for High-Cycle Multi-axial Fatigue

Notch Fatigue Life Prediction Considering Nonproportionality of Local Loading Path under Multiaxial Cyclic Loading

Fatigue Reliability Design and Assessment of Reactor Pressure Vessel Structures: Concepts and Validation

Fatigue life analysis of a composite materials structure using allowable strain criteria

A Novel Fatigue Evaluation Approach with Direct Steady Cycle Analysis (DSCA) Based on the Linear Matching Method (LMM)

Critical Plane–based Multiaxial Fatigue Life Prediction of Turbine Disk Alloys by Refining Normal Stress Sensitivity

Environmental Fatigue Correction Factor Model for Domestic Nuclear-Grade Low-Alloy Steel

Fretting Fatigue Life Model Under Combined Loading