Abstract:This study presents an enhanced multi-chamber micro-perforated panel absorber (MC-MPPA) with varying sub-chamber depths, offering ultra-broadband low-frequency sound absorption. Traditional micro-perforated panel absorbers are constrained by a limited bandwidth, necessitating impossibly small perforations for optimal low-frequency absorption. Our innovative design addresses these constraints with a lightweight, compact panel structure that uses varied chamber depths and unique porosities. Using the two-point impedance method from graph theory, an MC-MPPA was modeled and optimized. Notably, our MC-MPPA test pieces achieved impressive sound absorption coefficients experimentally of over 0.8 in the whole frequency ranges of [397–1000] and [698–1895] Hz. The absorber’s thickness is a mere 47 mm, equivalent to 1/18.2 and 1/10.5 of the sound wavelength at the minimum operational frequency, respectively. Theoretically, with a maximum sub-chamber depth of just 20 mm, average absorption coefficient values of 0.6780 and 0.6483 were observed in [200–3000] and [200–4000] Hz ranges, respectively. Our optimization algorithm permits the definition of practical geometric parameters, promising substantial industrial benefits. The results have been validated theoretically, numerically, and experimentally.

Perforated Multilayer Ultrawideband Absorber Based on Circuit Analog Absorber with Optimal Air Spaces

Ultrabroadband and Omnidirectional Absorbers Based on a Tandem Multilayer Structure

Compact Multilayer Film Structures for Ultrabroadband, Omnidirectional, and Efficient Absorption

Single-layer Wideband Circuit Analog Absorber Combined Polarization Conversion

On the design of ultra-wideband circuit analog absorber based on quasi-single-layer FSS

Flexible Design and Realization of Wideband Microwave Absorber with Double-Layered Resistor Loaded FSS

Design of a wide-band nearly perfect absorber based on multi-resonance with square patch

Ultra-wideband Passive Double-Layer Absorber Design from the Reflective Point

Ultrabroadband Double-Sided and Dual-Tuned Active Absorber for UHF Band

Switchable Reflective Point Design for Ultrabroadband Microwave Absorber

On the Design of Ultralow-Profile Broadband Absorber Based on Non-Foster Circuit

On the Design of Wideband Absorber Based on Multilayer and Multiresonant FSS Array

Design of a multilayer absorber for ultra‐wideband radar cross section reduction

Polarization-insensitive wide-angle multiband metamaterial absorber with a double-layer modified electric ring resonator array

Ultra-wideband Metamaterial Absorber Using Three-Layer Ring and Patch Resonators

Backend-Balanced-Impedance Concept for Reverse Design of Ultra-Wideband Absorber

Wide-Angle, Ultra-Wideband, Polarization-Independent Circuit Analog Absorbers

Ultra-Wideband Dual-Layer Magnetic Absorber With Active Impedance Matching

Ultra-broadband sound absorption in a compact multi-chamber micro-perforated panel absorber with varying depths

Design of Broadband Multi-Layer Metamaterial Absorber

Analysis and Enhancement of the Bandwidth of Ultrathin Absorbers Based on High-Impedance Surfaces