Abstract:Effect of varying surface structures of the inner rotating cylinder on characteristics of droplet formed in a liquid-liquid Taylor-Couette (TC) reactor is investigated. Two novel surface structures of inner cylinders, designed with axially corrugated surface (N40) and with typical three-dimensional roughness (NZ40), respectively, were adopted for the investigation. The high-speed camera visualization was used to measure the droplet size while CFD modelling was applied to predict the fluid dynamics of TC flows with such two inner cylinders and a smooth surface inner cylinder, thus revealing the effect of inner cylinder configuration on the droplet formation in the TC flows. The experimental results have clearly indicated that both the rotation speed and surface configuration variation of the inner cylinders affect the generated droplet size and distribution. As the rotation speed increases, the droplet size is obviously reduced for all types of inner cylinder configurations. Compared with the conventional smooth surface inner cylinder, the two new types of inner cylinders with special surface structures can produce much smaller droplets, especially for the case of N40 surface structure inner cylinder, with which the smallest droplet size was found at all the experimental conditions. CFD modelling results have demonstrated that the surface configurations of inner cylinder can significantly affect the turbulence generation, consequently altering the distributions of turbulent kinetic energy and local turbulence shear strain rate. As a result, the droplet size was found to be controlled by the change of the local turbulent dissipation rate that was strongly associated with the surface structures of inner cylinders. Empirical correlations that correlate the droplet size with the Weber number and Reynolds number were proposed based on the high-speed camera visualization data.(c) 2022 The Authors. Published by Elsevier Ltd. This is an open access article under the CC BY license (http:// creativecommons.org/licenses/by/4.0/).

On Reactive Thin Liquid Films Falling Down a Vertical Cylinder

Close-contact Melting of Shear-Thinning Fluids

Effect of Inner Cylinder Configuration on Liquid Droplet Dispersion and Size Distributions in a Taylor-Couette Reactor

Film Formation in a Horizontal Twin-Shaft Rotating Disk Reactor for Polymer Devolatilization

A Volatile Spray Zone Model and Experimentation in a Gas-Solid Fluidized Bed with Liquid Injection

Dynamics of a reactive falling film at large Péclet numbers. I. Long-wave approximation

Technical Note on the Effect of Lateral Thermal Convection on Freely Falling Liquid Film Flow

Thermal Non-Equilibrium Effect on Stabilities of Falling Liquid Films

Chemically reactive thin films: dynamics and stability

Modeling film flows down a rotating slippery cylinder

Falling Film Flow of a Viscoelastic Fluid along a Wall

Analysis on stability of thin falling liquid film along a heated vertical surface

Stability of gravity-driven viscous films flowing down a soft cylinder

Structural Effects in Partially-Wetting Thin Evaporating Liquid Films Near the Contact Line

Numerical study of infinitely fast chemical reaction-induced Kelvin–Helmholtz interfacial instability in a plane Poiseuille flow

Surface Tension Effect on Nonlinear Waves in a Thin Micropolar Liquid Film Flow Down along a Vertical Cylinder

Modes of a Liquid Film Falling Down a Vertical Cylinder at Different Contact Angles

Falling Film on Flexible Wall in the Limit of Weak Viscoelasticity

Liquid films falling down a vertical fiber: modeling, simulations and experiments

Simulation of the hydrodynamics and mass transfer in a falling film wavy microchannel

Non-isothermal rimming flow with the effects of surface shear and droplet impact