Abstract:A two-dimensional ultra performance liquid chromatography-quadrupole/time-of-flight mass spectrometry （2D-UPLC-Q/TOF-MS） method was established for the separation and structural analysis of the components in teicoplanin. This method effectively solved the problems associated with chromatographic systems， such as liquid chromatography-mass spectrometry （LC-MS）， which used a non-volatile phosphate buffer as the mobile phase and were not suitable for the rapid identification of impurities. Moreover， this method circumvented the complexities associated with locating and identifying impurities using the original method by re-establishing a chromatographic system suitable for LC-MS. In this study， for one-dimensional （1D） chromatography， the chromatographic separation was performed on an Octadecyl silica （ODS） hypersil column （250 mm×4.6 mm， 5 μm） with gradient elution using 3.0 g/L sodium dihydrogen phosphate buffer （pH 6.0）/acetonitrile=9/1 （v/v） as mobile phase A and 3.0 g/L sodium dihydrogen phosphate buffer （pH 6.0）/acetonitrile=3/7 （v/v） as mobile phase B. The column temperature was maintained at 30 ℃ and an ultraviolet detector was used at 254 nm for analysis. For 2D chromatography， desalting was performed on a Waters ACQUITY UPLC BEH C18 column （50 mm×2.1 mm， 1.7 μm） with gradient elution using ammonium formate buffer （pH 6.0） and acetonitrile as the mobile phases. The column temperature was maintained at 45 ℃. The MS data for the components and impurities were collected by positive ion electrospray ionization （ESI） using the full-information tandem MS mode （MSE）. The cone and nebulizer gas flow rates were set at 50 and 900 L/h， respectively. The ion source and nebulizer gas temperatures were set at 120 ℃ and 500 ℃， respectively. The ESI and cone needle voltages were set at 2500 and 60 V， respectively. The collision energy was set at 20-50 eV. The molecular formulas of the components and impurities were determined using their exact masses and isotope distributions， and the structural components and impurities of teicoplanin were deduced from their fragment ions according to the fragmentation pathway of the TA2-2 component. Moreover， the 10 components reported in the European Pharmacopoeia 10.0 were analyzed and 22 impurities of teicoplanin were identified by 2D-UPLC-Q/TOF-MS. Three new impurities and two characteristic fragment ions of the teicoplanin parent nucleus were detected， and the fragmentation pathway of TA2-2 was deduced. Using this method， 1D-UPLC is applicable for the accurate qualification of components based on relative retention times， and 2D-UPLC-Q/TOF-MS is suitable for the rapid identification of the structure of components based on their fragment ions. The results indicate that 2D-UPLC-Q/TOF-MS may be used to analyze the structure of impurities in teicoplanin based on their exact masses， isotope distributions， and fragment ions. The method is rapid， simple， and sensitive， which provides a novel strategy for the quality control and process optimization of teicoplanin.

Boronate Affinity Glycosyl Molecularly Imprinted Polymer Microspheres for the Determination of Teicoplanin Using Ultra-High Performance Liquid Chromatography Coupled with Tandem Mass Spectrometry.

The study on the creation of boronate affinity-based oriented imprinted silica nanoparticles and their selective recognition of glycopeptide antibiotics in food and water

Glycosyl imprinted mesoporous microspheres for the determination of glycopeptide antibiotics using ultra-high performance liquid chromatography coupled with tandem mass spectrometry

A Highly Efficient Fluorescent Turn-Off Nanosensor for Quantitative Detection of Teicoplanin Antibiotic from Humans, Food, and Water Based on the Electron Transfer between Imprinted Quantum Dots and the Five-Membered Cyclic Boronate Esters

Quantification of Teicoplanin in Human Plasma by Liquid Chromatography with Ultraviolet Detection

Analysis using fluorescence polarization immunoassay for unbound teicoplanin concentration in serum

LC-MS for Simultaneous Determination of Vancomycin and Teicoplanin in Patient Plasma and its Application to Therapeutic Drug Monitoring

Hyperbranched Molecularly Imprinted Photoactive Polymers and Its Detection of Tetracycline Antibiotics

Magnetic microsphere-based methods to study the interaction of teicoplanin with peptides and bacteria

Bimetallic cerium/copper organic framework-derived cerium and copper oxides embedded by mesoporous carbon: Label-free aptasensor for ultrasensitive tobramycin detection

Selective and fast removal and determination of β-lactam antibiotics in aqueous solution using multiple templates imprinted polymers based on magnetic hybrid carbon material

Direct and Highly Selective Drug Optosensing in Real, Undiluted Biological Samples with Quantum-Dot-Labeled Hydrophilic Molecularly Imprinted Polymer Microparticles

Open Tubular Capillary Electrochromatography with Block Co-Polymer Coating for Separation of Β-Lactam Antibiotics

A LC-MS-MS assay for simultaneous determination of two glycopeptides and two small molecule compounds in human plasma.

Metal ion mediated molecularly imprinted polymer for selective capturing antibiotics containing beta-diketone structure.

Surface molecularly imprinted solid-phase extraction for the determination of vancomycin in plasma samples using HPLC-MS/MS

Selective Solid-Phase Extraction of Tebuconazole in Biological and Environmental Samples Using Molecularly Imprinted Polymers

[Analysis of teicoplanin impurities by two-dimensional ultra performance liquid chromatography-quadrupole/time-of-flight mass spectrometry]

Target-induced Strand Displacement-based Electrochemical Aptasensor for the Determination of Tobramycin in Milk by Differential Pulse Voltammetry (DPV)

Preparation and Evaluation of Molecularly Imprinted Membrane of Teicoplanin

Fast, sensitive LC–MS resolution of -hydroxy acid biomarkers via SPP-teicoplanin and an alternative UV detection approach