Additively Manufactured Metal-Only Waveguide-Based Millimeter-Wave Broadband Achromatic Reflectarrays

Jianfeng Zhu,Yang Yang,Shaowei Liao,Quan Xue

DOI: https://doi.org/10.1109/tap.2023.3278799

IF: 5.7

2023-01-01

IEEE Transactions on Antennas and Propagation

Abstract:This communication demonstrates additively manufactured metal-only waveguide-based tri-band and broadband reflectarray antennas. The unit cell (UC) is implemented by cascading two metal waveguide sections with different cut-off frequencies (fc1 and fc2 (fc1< fc2)). When illuminated with the feed antenna, the reflectarray provides different reflection paths to compensate for the spatial phase delay over triple bands, fl (fl<fc1), fm (fc1 <fm<fc2), and fh (fh>fc2). By tuning the length of the two waveguide sections and vertically adjusting the position of the UC, the phase-shifting over the triple bands can be independently controlled. In addition, because of the sharp selectivity of the waveguide, a reflectarray with the broadband achromatic feature can be achieved by properly selecting the tri-band’s frequency and the cut-off frequency of the waveguides. A tri-band reflectarray centering at 25 GHz (low-band), 32 GHz (middle-band), and 37 GHz (high-band) is designed firstly to demonstrate the independent beam shaping over triple bands. Then, two waveguide-based reflectarrays with the broadband achromatic feature are designed, which show stable performance from 22 GHz to 38 GHz with a relative bandwidth of 53.3%. The prototypes are conveniently fabricated using additive manufacturing, and their performance is experimentally verified.

telecommunications,engineering, electrical & electronic