MEMS Piezo-Resistive Force Sensor Based on DC Sputtering Deposited Amorphous Carbon Films

Xin Ma,Xiaoshan Tong,Peng Guo,Yulong Zhao,Qi Zhang,Hanchao Li,Rende Chen,Aiying Wang
DOI: https://doi.org/10.1016/j.sna.2019.111700
2020-01-01
Abstract:The rapid growing demand of micro-electromechanical system (MEMS) sensors brings an urgent need for high performance and low cost sensitive materials. In this work, amorphous carbon (a-C) film was in-situ deposited on silicon substrate as strain sensitive component using economical direct current (DC) magnetron sputtering process and the a-C sensor was systematically designed, fabricated and tested. By adjusting the negative bias voltage in the range of 0-400 V, the gauge factor (GF) of the a-C film was adjusted within the range of 3.3-6.9. What's more, the film's sp(2) cluster size played an important role in their piezo-resistive performance and conductivity, which illustrated the thick-film resistors (TFRs) theory. Additionally, CAFM results also supported the applying of TFRs theory in this work. Benefiting from the outstanding performance of a-C film, the MEMS force sensor, consisted a Wheatstone full-bridge with four a-C piezo-resistors, had a sensitivity of 9.8 mu V/V/mN and non-linearity about 2.0% FS in the testing range of 0-210 mN, while it also showed a good repeatability. These investigations provided deeper insight into the piezo-resistive behavior of a-C film and contributed to the development of high performance and more economical sensitive materials for MEMS sensors. (C) 2019 Elsevier B.V. All rights reserved.
What problem does this paper attempt to address?