Abstract:The optimization of thermal management (i.e. improving heat generation and dissipation) in a proton exchange membrane fuel cell (PEMFC) is a vital method to enhance its energy conversion efficiency. However, few studies have focused on the temperature uniformity in a massive PEMFC stack with a coolant flow channel. The aim of this study is to investigate the temperature characteristics and power performance affected by the inlet coolant condition in a massive PEMFC stack and establish a correlation of the temperature uniformity with the affected inlet coolant temperature for thermal management and power performance improvements in PEMFCs. The power density of a massive PEMFC stack with an active area of 326 cm 2 (302 mm × 108 mm) of the designed stack cells with a coolant flow channel were experimentally evaluated, and the thermal characteristics were also analyzed using monitored temperatures inside specific stack cells by considering the different inlet coolant temperatures of 50 °C, 60 °C and 70 °C. It was found that the stack had the greatest power performance and minimum temperature increment of the inlet coolant at a temperature of 70 °C. The water phase transition heat transfer inside the stack was found to play a significant role in the thermal balance. The temperature distribution of the stack cell had a symmetrical convex curve from the center to the margin. The temperature gradient of the stack cell along the coolant flow direction was introduced to characterize the temperature uniformity. The linear development between the temperature gradient and the current density was determined adequately using a curve fitting. In addition, a lower fitting linear slope was obtained for a higher inlet coolant temperature, and this signified that a higher inlet coolant temperature could improve the temperature uniformity and power performance of PEMFCs.

Temperature Control of PEMFC Based on Optimal Power Consumption

Research on modeling and control of PEMFC cooling system

Adaptive thermal control for PEMFC systems with guaranteed performance

Thermal management of an open-cathode PEMFC based on constraint generalized predictive control and optimized strategy

Design and optimization of thermal strategy to improve the thermal management of proton exchange membrane fuel cells

Investigation of optimal operating temperature for the PEMFC and its tracking control for energy saving in vehicle applications

Model-based decoupling control for the thermal management system of proton exchange membrane fuel cells

Study on Diesel Engine Coolant Temperature Control Strategy with Feedforward

Thermal management for an air coolant system of a proton exchange membrane fuel cell using heat distribution optimization

Temperature Optimization and Control of Optimal Performance for a 300W Open Cathode Proton Exchange Membrane Fuel Cell

Control of a PEM Fuel Cell Cooling System

Optimization of control strategy for air-cooled PEMFC based on in-situ observation of internal reaction state

Sliding-mode-based Temperature Regulation of a Proton Exchange Membrane Fuel Cell Test Bench

MPC-based thermal management for water-cooled proton exchange membrane fuel cells

Structural Design and Strategy Optimization of PEMFC in Thermal Management

PEM Fuel Cell Thermal Management Strategy Based on Multi-model Predictive Control

Numerical study on heat transfer characteristics and performance evaluation of PEMFC based on multiphase electrochemical model coupled with cooling channel

Enhancing fuel cell performance through a dual MPC strategy for coordinated temperature management

A Review of Thermal Management of Proton Exchange Membrane Fuel Cell Systems

Experimental study of the thermal and power performances of a proton exchange membrane fuel cell stack affected by the coolant temperature

Thermal Management of Proton‐Exchange Membrane Fuel Cells with Enhanced Fuzzy Control via an Improved Whale Optimization Algorithm