Abstract:With increasing of the geometry of various space structures, they easily bring low-frequency, longtime and more bending modal responses. Therefore, it is necessary to suppress effectually the vibration responses above. Adaptive structure design is a common method using the piezoelectric material. However, the conventional piezoelectric actuators hardly control effectually these responses owing to the inadequate actuated performance. This paper first introduces the design of a new dual-stack piezoelectric actuator, which has the bidirectional (can act in both push and pull directions) actuated advantage, using a pair of matching piezoelectric stacks within the actuator house. Two stacks are integrated in a mechanically opposing configuration and are electrically operated out of phase. Further, we design the piezoelectric bending actuator using two dual-stack piezoelectric actuators and a fixed device, and then a five-meter hoop truss can use it to perform the active vibration control. Here the truss is mainly applied to simulate a large hoop mesh antenna. Then, we set up the active control system based on the PD algorithm and build the simulation model by the Matlab/Simulink platform. The simulation results point out the PBA can produce enough actuated moment to suppress effectually the first-order modal response of the hoop truss. Finally, we perform three experiments including one uncontrolled case and two PD controlled cases. The two control cases mainly consider whether the driving voltages are offset or not. The experimental results of both control cases are in accordance with the better simulated analysis. The control ratios of the decay time of the first-order modal response are up to more than 30 percent in the simulations and experiments. That is, this bending actuator has good application foreground in controlling the bending modes of the spacecrafts with a larger size.

Adaptive Switching Vibration Control of Flexible Piezoelectric Structure

A low-power circuit for piezoelectric vibration control by synchronized switching on voltage sources

Enhanced Semi-active piezoelectric vibration control method with shunt circuit by energy dissipations switching

A Hybrid Photovoltaic/flexoelectric Actuation Mechanism Applied to Precision Actuation and Vibration Control of Beams

Active Pneumatic Vibration Control By Using Pressure And Velocity Measurements And Adaptive Fuzzy Sliding-Mode Controller

Hysteresis Identification and Adaptive Vibration Control for A Smart Cantilever Beam by A Piezoelectric Actuator

Active micro-vibration isolation system for adaptive vibration suppression tests using piezoelectric stack actuator

Adaptive vibration suppression system: An iterative control law for a piezoelectric actuator shunted by a negative capacitor

Dynamics and Distributed Vibration Controls of Flexible Manipulators; Integrated Distributed Sensing and Active Piezoelectric Actuator

Adaptive Vibration Control of Flexible Plate Structures with Actuator Placement Optimization

Simulation and Experiment of Active Vibration Control Based on Flexible Piezoelectric MFC Composed of PZT and PI Layer

Hysteresis Model and Adaptive Vibration Suppression for a Smart Beam with Time Delay

Adaptive modal vibration control for smart flexible beam with two piezoelectric actuators by multivariable self-tuning control

Actuator Placement Optimization and Adaptive Vibration Control of Plate Smart Structures

Hybrid Control Scheme for Vibration Suppression of a Flexible Manipulator

Vibration Control with Optimized Piezoelectric Shunt Damping System Using Pole Placement

PD control for vibration attenuation in Hoop truss structure based on a novel piezoelectric bending actuator

Piezoelectric vibration energy harvesting with asymmetric hybrid bracing beam

Active Vibration Control of Thin-Walled Structure with Inertial Piezoelectric Actuator Based on Fuzzy Adaptive PID Algorithm

Active Vibration Control of an Axially Moving Cantilever Structure Using PZT Actuator

A Fuzzy-Logic Based Dual-Purpose Adaptive Circuit for Vibration Control and Energy Harvesting Using Piezoelectric Transducer