Abstract:The equivalent circuit simulation plays an important role in the design of ultrasound transducer. However, the existing methods are difficult to achieve the effect of matching and backing layer, and not able to accurately simulate the transducer with cable. Especially in the application of high frequency ultrasound, the long cable has a great influence on the performance of the transducer. To overcome these limitations, this paper proposed an improved equivalent circuit method, which combined Leach model and transmission line model. It can realize the complete simulation of ultrasound transducer with a long cable, matching layer, and backing layer in PSPICE circuit simulation software when the parameters were measured. Its principles were briefly introduced, and ultrasound transducers with different frequencies (12 and 20 MHz), different matching layers, and different cable lengths (0.5–2.5 m) were designed and fabricated to verify the effectiveness of the method, which is also compared with the traditional KLM method using PiezoCAD. The experiment results showed that the long cable, matching layer, and backing layer have a significant impact on the performance of high frequency ultrasound transducers, and this proposed method has good agreement with these results. Moreover, for the simulation of the complete transducer, the effect of this method is better than KLM model. Besides, this method does not need to know the specific equivalent circuit of matching, backing layer, or cable wire, it can accurately predict the impedance and phase of the transducer through the material parameters, which is very helpful for the material selection and optimization of subsequent transducer design and fabrication. The study indicates that this improved equivalent circuit method is suitable to be applied in the general circuit simulation software and provides strong support for the high frequency transducer and system design.

Frequency-dependent equivalent modelling of broadband air-coupled transducers

Model-Based Analysis and Regulating Approach of Air-Coupled Transducers with Spurious Resonance.

Wideband Description of the Finite-Ground Coplanar Waveguide-Type Structures with Discontinuities

Modelling of Reciprocal Transducer System Accounting for Nonlinear Constitutive Relations

Design Method of Multi-Sine Signal for Broadband Impedance Measurement Considering Frequency Coupling Characteristic

Perturbation Amplitudes Design Method Based on Confidence Interval Evaluation for Impedance Measurement

Modelling of received ultrasonic signals based on variable frequency analysis

Method for Accurately Measuring the Power-Frequency Parameters of Ehv/Uhv Transmission Lines

Adaptive Frequency Adjustment Method for Impedance Measurement

Equivalent Circuit Analysis with Experimental Verification for Barrel-Stave Flextensional Transducers and Arrays.

A Study on the Multi-Freedom Broadband Impedance Model for Time-Domain Simulations

An Equivalent Modeling Method for Wideband Magnetic Radiation Interference of Power-Electronic Equipment

An Enhanced Broadband Continuous Extraction Approach for Complex Propagation Constants of Differential Transmission Lines

A Noise Interference Suppression Method with Optimized Frequency Adjustment for Impedance Measurement

High-Order Mode-Matching-Based Single-Cavity Coaxial Transducer for Broadband Measurement of Complex Permittivity

Low-Order Approximation Method for Frequency-Dependent Transmission Line Model

Construction and Validation of a Broadband Time Domain Impedance Boundary Condition

An Improved Equivalent Circuit Simulation of High Frequency Ultrasound Transducer

A Research for Broadband Modeling Method of Electro-Absorption Modulator

A New Wideband Modeling Method Of Converter Transformer

Broadband Port Circuit Model for Distribution Transformers Based on Frequency Impedance Analysis