Abstract:Fine chemicals produced via batch crystallization with properties dependent on the crystal size distribution require precise control of supersaturation, which drives the evolution of crystal size over time. Model predictive control (MPC) of supersaturation using a mechanistic model to represent the behavior of a crystallization process requires less experimental time and resources compared with fully empirical model-based control methods. Experimental characterization of the hexamine-ethanol crystallization system was performed in order to collect the parameters required to build a one-dimensional (1D) population balance model (PBM) in gPROMS FormulatedProducts software (Siemens-PSE Ltd.). Analysis of the metastable zone width (MSZW) and a series of seeded batch cooling crystallizations informed the suitable process conditions selected for supersaturation control experiments. The gPROMS model was integrated with the control software PharmaMV (Perceptive Engineering Ltd.) to create a digital twin of the crystallizer. Simulated batch crystallizations were used to train two statistical MPC blocks, allowing for in silico supersaturation control simulations to develop an effective control strategy. In the supersaturation set-point range of 0.012-0.036, the digital twin displayed excellent performance that would require minimal controller tuning to steady out any instabilities. The MPC strategy was implemented on a physical 500 mL crystallizer, with the simulated solution concentration replaced by in situ measurements from calibrated attenuated total reflection-Fourier transform infrared (ATR-FTIR) spectroscopy. Physical supersaturation control performance was slightly more unstable than the in silico tests, which is consistent with expected disturbances to the heat transfer, which were not specifically modeled in simulations. Overall, the level of supersaturation control in a real crystallizer was found to be accurate and precise enough to consider future adaptations to the MPC strategy for more advanced control objectives, such as the crystal size.

A Modified Method for Modelling, Optimization and Control of an Anti-Solvent Crystallization Process

Machine Learning Modeling and Predictive Control of the Batch Crystallization Process

Membrane-Assisted Antisolvent Crystallization: Interfacial Mass-Transfer Simulation and Multistage Process Control

A Study on Process Modeling and Optimization for Batch Crystallization

Crystallization solvent design based on a new quantitative prediction model of crystal morphology

Closed-loop Control of Crystal Shape in Seeded Cooling Crystallisation Experiments

Advances in modeling and dynamic optimization of batch crystallization

Model-based Design for Water-Soluble Crystals with Anti-Caking Function by the Feedback Between Caking Prediction and Crystallization Control

Use of Wet Milling Combined with Temperature Cycling to Minimize Crystal Agglomeration in a Sequential Antisolvent-Cooling Crystallization

Development of a Digital Twin for the Prediction and Control of Supersaturation during Batch Cooling Crystallization

Digital Design of an Agrochemical Crystallization Process via Two-Dimensional Population Balance Modeling

Modeling and Optimization of the Para-Xylene Continuous Suspension Crystallization Separation Process via a Morphology Technique and a Multi-Dimensional Population Balance Equation

Optimal control of crystallization of alpha-lactose monohydrate

Modeling and dynamic simulation of batch crystallization process

Interface‐based Crystal Particle Autoselection Via Membrane Crystallization: from Scaling to Process Control

A Comparative Study of Model-Based Control Techniques for Batch Crystallization Process

A Grand Product Design Model for Crystallization Solvent Design

Development and Validation of a Raman Spectroscopy Concentration Calibration Model to Enhance Crystallization Kinetic Model-Based Control: A Case Study of DL-methionine

Process Optimization of Para-xylene Crystallization Separation Process Via Morphology Approach, Multi-dimensional Population Balance Equation, and Equation-Oriented Models.

Process Intensification and Control Strategies in Cooling Crystallization: Crystal Size and Morphology Optimization of Α-Paba

Multiscale Modeling and Simulation of Macromixing, Micromixing, and Crystal Size Distribution in Radial Mixers/Crystallizers