Abstract:This study initially describes a new nanosensing method for colorimetric detection of iron (III) (Fe3+) ions with high sensitivity and selectivity using one of the most basic optical properties of colloids (namely the Tyndall effect, TE). It adopts colloidal Au nanoparticles (AuNPs) prepared by sodium citrate reduction as the light scattering signaling probes, and 3,3′,5,5′ -tetramethylbenzidine (TMB) as recognition reagent. In the presence of Fe3+ ions, the TMB can be oxidized to its positively-charged product (TMBox) to induce the aggregation of the negatively-charged AuNP via electrostatic adsorption, leading to a significant enhancement in their TE which positively relies on the analyte concentration in the sample. The results demonstrate that this nanosensor is simple, rapid, low-cost, and portable, because it takes just 15 min to complete one assay run where only a laser pointer pen is utilized as the hand-held light source to stimulate the TE creation and a smartphone as the mobile quantitative TE reader. In particular, it can linearly detect the Fe3+ in a level range from 0.5 to 64 µM with a detection limit of ∼ 370 nM, offering a ∼ 37-fold improvement in sensitivity but with ∼ 9 times reduction in nanoprobe consumption per assay in comparison with the most common AuNP-based naked-eye method with surface plasmon resonance signaling strategy. Its accuracy and practicability are additionally validated by determining Fe3+ ions in real complex samples including tap water, commercially-available drinking water and human serum with acceptable recovery results between 85.96 and 115.52%. To the best of our knowledge, this is the first report of designing an equipment-free quantitative visual assay for the Fe3+ analysis by taking the advantage of the TE of colloids like AuNP tested herein.

Colorimetric Detection of Iron (II) Using 4-Mercaptobenzoic Acid and 3,3′,5,5′-Tetramethylbenzidine Modified Silver Nanoparticles

Colorimetric Detection of Cu2+ Using 4-Mercaptobenzoic Acid Modified Silver Nanoparticles

Selective sensing of submicromolar iron(III) with 3,3',5,5'-tetramethylbenzidine as a chromogenic probe.

Colorimetric detection of Mn2+ using silver nanoparticles cofunctionalized with 4-mercaptobenzoic acid and melamine as a probe.

Colorimetric Detection of Cr3+ in Aqueous Solution Based on Cofunctionalized Silver Nanoparticles Modified with 4-Nitrobenzenethiol and 4-Mercaptobenzoic Acid

Colorimetric Detection of Lead (II) Based on Silver Nanoparticles Capped with Iminodiacetic Acid

Simple, rapid, portable and quantitative sensing of Fe3+ ions via analyte-triggered redox reactions mediating Tyndall effect enhancement of Au nanoparticles

An optical and visual multi-mode sensing platform base on nitrogen, sulfur, boron co-doped carbon dots for rapid and simple determination of ferric ions in water

An Ultra-Sensitive and Colorimetric Sensor for Copper and Iron Based on Glutathione-Functionalized Gold Nanoclusters.

Dual-Mode Sensing of Fe(III) Based on Etching Induced Modulation of Localized Surface Plasmon Resonance and Surface Enhanced Raman Spectroscopy

Facile Preparation of Tannic Acid-Gold Nanoparticles for Catalytic and Selective Detection of Mercury(II) and Iron(II) Ions in the Environmental Water Samples and Commercial Iron Supplement

Colorimetric Determination of Copper Ion Based on the Silver-Coated Gold Nanobipyramids

Two Tetrapodal Schiff Bases Acting As Colorimetric Sensors for Iron in Environmental Water Samples

An Iron(III) Sensing Membrane Based on Fluorescence Quenching

An Expeditious and Sensitive Microprecipitation Approach Using Chrome Azurol S and Cetyltrimethylammonium Bromide for Visual Detection of Fe(II) and Fe(III) in Water

A Novel Ratiometric Probe Based on Nitrogen-Doped Carbon Dots and Rhodamine B Isothiocyanate for Detection of Fe3+ in Aqueous Solution

Colorimetric Detection of Ba2+, Cd2+ and Pb2+ Based on a Multifunctionalized Au NP Sensor.

A New Rapid Colorimetric Detection Method of Mn2+ Based on Tripolyphosphate Modified Silver Nanoparticles

Understanding Variations in Ferrate Detection through the ABTS Method in the Presence of Electron-Rich Organic Compounds

A Simple, Sensitive and Selective Spectrophotometric Method for Determining Iron in Water Samples

Colorimetric Fluorescence of a 2,4,5‐Triaryl Imidazole‐Based Sensor for the Selective Detection of Iron