Feasibility and performance evaluation of film cooling using incoming air in a gel-fueled scramjet
Hongbin Yan,Song Yang,Wei-Tao Wu,Feng Feng
DOI: https://doi.org/10.1016/j.applthermaleng.2024.123169
IF: 6.4
2024-04-20
Applied Thermal Engineering
Abstract:Gel-fuels with metal particles have high specific impulse, lowered volatility and reduced risk of leakage compared with conventional liquid fuels, which are promising fuel candidates in scramjet engines. However, these non-Newtonian fluids with unique rheological properties are not suitable for active cooling. To address this issue, this paper proposes a film cooling strategy using the incoming air from the scramjet inlet, without introducing extra coolant tanks. Design of the coolant transport channel and the cooling slot is conducted; and the corresponding feasibility and cooling performance are evaluated within the flight Mach number range of 5.6–7.4 by validated numerical models. The numerical results reveal that the incoming air is successfully compressed into the combustor; in addition, the introduction of the film cooling has negligible effects on the mass flow coefficient, total pressure recovery coefficient and the compression ratio of the scramjet inlet. The sharp corners of the coolant inlet induce a system of shock waves and expansion waves, which lower the static and total pressure near the fuel injector by 2.5 % and 7 %, respectively. Such a fact implies limited effects on the combustion performance. Due to the high backpressure in the combustor, a normal shock wave forms in each coolant channel, which helps to further compress the coolant. Within 0–10 mm downstream the cooling slot, the film cooling effectiveness is above 0.5, which implies evidently reduced combustor wall temperature. The interaction and heat transfer mechanisms between the mainstream and the coolant flow are also explored based on the pressure field, flow field and the temperature field. These mechanisms are beneficial to optimize further the present cooling strategy.
energy & fuels,engineering, mechanical,thermodynamics,mechanics