Influence of the Al2O3/SiO2 mass ratio and gas composition on the viscous behavior and structure of Cr-containing stainless steel slags

Zhanjun Wang,Il Sohn
DOI: https://doi.org/10.1016/j.ceramint.2019.09.048
IF: 5.532
2020-01-01
Ceramics International
Abstract:This study investigated the effects of the Al2O3/SiO2 mass ratio and gas composition on the viscosity and structure of Cr-containing CaO-SiO2-MgO-Al2O3-CrOx stainless steel slags. The wet chemical analysis method was used to identify the Cr3+/Cr2+ ratio, and XPS (X-ray photoelectron spectroscopy) and Al-27 MAS NMR (magic angle spinning nuclear magnetic resonance) were used to correlate the structural units comprising the melt to the viscosity measurements. The results showed that the break temperature (T-Br) corresponded to the temperature when the crystallization fraction increased rapidly, When the Al2O3/SiO2 mass ratio was in the range between 0.125 and 1.0, the viscosity gradually increased as the Al2O3/SiO2 mass ratio increased. Similar viscosity trends were observed for gas compositions with higher oxygen partial pressures, which was correlated to an increased degree of polymerization (DOP) of the slag structure. In addition, the variation in the Cr3+/Cr2+ ratio, which decreased with increasing Al2O3/SiO2 mass ratios and increased with higher oxygen partial pressures, correlated well with the viscous behavior of the slags, the variation trends of [AlO4]- and [AlO5]-structural units, and the increased DOP of the slags.
What problem does this paper attempt to address?