Abstract:Ultrasonic flowmeters (UFMs) based on the principle of transit time difference are widely used in process industries. The transit time difference is obtained through analyzing received acoustic signals generated by a couple of transducers located upstream and downstream respectively. The quality of received acoustic signal will directly affect the measurement accuracy of UFM. For this reason, a measurement-calculation coupled approach combining measurement tools and numerical simulation for calculating the acoustic signal of UFM is proposed in this paper. The method can predict the acoustic signals of UFM with different flowrates. First, important boundary condition (vibration velocity on transmitter transducer surface) is measured by measurement tool, which can reduce computational complexity and also avoid modeling transmitter transducers. Second, simulating the wave propagation (difficult to access experimentally) within moving medium by using the measured vibration velocity. Third, obtaining the transfer function of receiver by comparing estimated force acting on the receiver transducer surface with measured voltage signal from receiver, which can avoid modeling receiver transducer. Finally, predicting the received acoustic signal at different flowrates by using the transfer function. The rationality of predicted data was validated by comparing experimental and predicted acoustic signal on receiver transducer at different flowrates. A good agreement between simulated and experimental data was obtained, which means that the working processes of the acoustic signal generated by actual transducers inside UFMs can be accurately predicted based on this method. Analysis of the predicted results will provide good guides and advices to the design of UFMs involving actual application.

Phase-frequency Characteristic Based Measurement of Sodium Flow Rate Using PMSF with Embedded Bluff Body

Transducer analysis and signal processing of PMSF with embedded bluff body

Research on Nonlinearity in In situ Calibration of Permanent Magnet Sodium Flowmeter Without Bluff Body

In Situ Calibration of a Permanent-Magnet Sodium Flowmeter Without a Bluff Body Based on Multi-Pair Electrode Signal Subtraction

Study of No-liquid Calibration Technique for the Medium-and-large Diameter Electromagnetic Flowmeter

Adaptive Filtering Based Sodium Flow Measurement Method for In-Situ Calibration

Signal Modeling of Permanent Magnet Sodium Flowmeter With Embedded Vortex Generator Based on Transit Time Series

Error correction method for in-situ calibration of permanent magnet sodium flowmeter without bluff body based on low-frequency suppression

A New Method for Flow Rate Measurement in Millimeter-Scale Pipes.

Calculation and Matching of Correction Frequency Band in In Situ Calibration of Permanent Magnet Sodium Flowmeter Without Vortex Generator

Magnetic Field Estimation in Measurement Dead Domain for Dry Calibration of Electromagnetic Flowmeter

Numerical evaluation of SmCo permanent magnet flowmeter measuring sodium flow in a low flow rate regime using FLUENT/MHD module

Reconstruction of the magnetic field in the measuring volume of an electromagnetic flow sensor

A Fault-Tolerant Flow Measuring Method Based on PSO-SVM with Transit-Time Multipath Ultrasonic Gas Flowmeters

A Method Combining Measurement Tool and Numerical Simulation for Calculating Acoustic Signals of Ultrasonic Flowmeter

Dry Calibration Technique of Electromagnetic Flowmeters

Dry Calibration of Electromagnetic Flowmeters Based on Numerical Models Combining Multiple Physical Phenomena (Multiphysics)

Development of a vortex flowmeter with good performance at low-flowrate

A study of mass flow rate measurement based on the vortex shedding principle

Gas Flow-Rate Measurement Using a Transit-Time Multi-Path Ultrasonic Flow Meter Based on PSO-SVM.

Electromagnetic Field and Temperature Field Analysis of Coil Type Lead-Bismuth Electromagnetic Flowmeter