Abstract:Versatile, in situ sensing and continuous monitoring capabilities are critically needed, but challenging, for components made of solid woven carbon fibers in aerospace, electronics, and medical applications. In this work, we proposed a unique concept of integrated sensing technology on woven carbon fibers through integration of thin-film surface acoustic wave (SAW) technology and electromagnetic metamaterials, with capabilities of noninvasive, in situ, and continuous monitoring of environmental parameters and biomolecules wirelessly. First, we fabricated composite materials using a three-layer composite design, in which the woven carbon fiber cloth was first coated with a polyimide (PI) layer followed by a layer of ZnO film. Integrated SAW and metamaterials devices were then fabricated on this composite structure. The temperature of the functional area of the device could be controlled precisely using the SAW devices, which could provide a proper incubation environment for biosampling processes. As an ultraviolet light sensor, the SAW device could achieve a good sensitivity of 56.86 ppm/(mW/cm2). On the same integrated platform, an electromagnetic resonator based on the metamaterials was demonstrated to work as a glucose concentration monitor with a sensitivity of 0.34 MHz/(mg/dL).The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acssensors.0c00948?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acssensors.0c00948</a>.FEA simulation to evaluate the heat transfer in the SAW device (Figure SI1); I–V curves of the SAW device with the wavelength of 64 μm under different intensities of the UV illumination (Figure SI2) (<a class="ext-link" href="/doi/suppl/10.1021/acssensors.0c00948/suppl_file/se0c00948_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.

A Fully Integrated Biosensing Platform Combining Acoustofluidics and Electromagnetic Metamaterials

Flexible Platform of Acoustofluidics and Metamaterials with Decoupled Resonant Frequencies

A single-chip biosensing platform integrating FBAR sensor with digital microfluidic device

Acoustofluidics-Assisted Engineering of Multifunctional Three-Dimensional Zinc Oxide Nanoarrays

Flexible and Integrated Sensing Platform of Acoustic Waves and Metamaterials based on Polyimide-Coated Woven Carbon Fibers

Photonic metamaterial surfaces for digital resolution biosensor microscopies using enhanced absorption, scattering, and emission

Sensors Based on Saw and Fbar Technologies

Solid-State Microfluidics with Integrated Thin-Film Acoustic Sensors.

Monolithic integrated system with an electrowetting-on-dielectric actuator and a film-bulk-acoustic-resonator sensor

Fully Integrated Pneumatic-Free and Magnet-Free CMOS Ferrofluidic Platform for Comprehensive Biomolecular Processing

An ultrahigh frequency dielectric sensor for microdroplet detection using a split ring resonator-based microfluidic chip

Acoustofluidic localization of sparse particles on a piezoelectric resonant sensor for nanogram-scale mass measurements

A Metamaterial Based Microfluidic Sensor for Permittivity Detection of Liquid

A Highly Integratable Microfluidic Biosensing Chip Based on Magnetoelastic-Sensor and Planar Coil

Feedthrough Engineering to Enable Resonant Sensors Working in Conductive Medium for Bio Applications

Acoustofluidics-enhanced biosensing with simultaneously high sensitivity and speed

Lab-on-a-chip for High Frequency Acoustic Characterization

A Design of Metamaterial Inspired Resonator for Multifrequency Fluidic Sensors

A novel metamaterial microfluidic seneor forbiochemical sensing

Acoustofluidics for Simultaneous Droplet Transport and Centrifugation Facilitating Ultrasensitive Biomarker Detection.

Microfluidic Mixing and Simulation via Surface Acoustic Wave Driving