Abstract:Piezoelectric wafer active sensors (PWAS) have been proven a valuable tool in structural health monitoring. Piezoelectric wafer active sensors are able to send and receive guided Lamb/Rayleigh waves that scan the structure and detect the presence of incipient cracks and structural damage. In-situ thin-film active sensor deposition can eliminate the bonding layer to improve the durability issue and reduce the acoustic impedance mismatch. Ferroelectric thin films have been shown to have piezoelectric properties that are close to those of single-crystal ferroelectrics but the fabrication of ferroelectric thin films on structural materials (steel, aluminum, titanium, etc.) has not been yet attempted. In this work, in-situ fabrication method of piezoelectric thin-film active sensors arrays was developed using the nano technology approach. Specification for the piezoelectric thin-film active sensors arrays was based on electro-mechanical-acoustical model. Ferroelectric BaTiO3 (BTO) thin films were successfully deposited on Ni tapes by pulsed laser deposition under the optimal synthesis conditions. Microstructural studies by X-ray diffractometer and transmission electron microscopy reveal that the as-grown BTO thin films have the nanopillar structures with an average size of approximately 80 nm in diameter and the good interface structures with no inter-diffusion or reaction. The dielectric and ferroelectric property measurements exhibit that the BTO films have a relatively large dielectric constant, a small dielectric loss, and an extremely large piezoelectric response with a symmetric hysteresis loop. The research objective is to develop the fabrication and optimum design of thin-film active sensor arrays for structural health monitoring applications. The short wavelengths of the micro phased arrays will permit the phased-array imaging of smaller parts and smaller damage than is currently not possible with existing technology.

HIGH SENSITIVITY SURFACE ACOUSTIC WAVE STRAIN SENSOR BASED ON PMN-PT THICK FILM

Highly Sensitive Surface Acoustic Wave Flexible Strain Sensor

Ferroelectric Thin-Film Active Sensors for Structural Health Monitoring

Highly Sensitive and Fast Response Strain Sensor Based on Evanescently Coupled Micro/nanofibers

Flexible Surface Acoustic Wave Strain Sensor Based on Single Crystalline LiNbO3 Thin Film

Flexible Dual-Mode Surface Acoustic Wave Strain Sensor Based on Crystalline LiNbO3 Thin Film

Design of SAW Sensor for Longitudinal Strain Measurement with Improved Sensitivity

High Temperature Surface Acoustic Wave Sensor with Strain Isolation Structure

Flexible Strain Sensor Based on Ultra-Thin Quartz Plate

Flexible Surface Acoustic Wave Broadband Strain Sensors Based on Ultra-Thin Flexible Glass Substrate

A Flexible Piezoelectric Strain Sensor Array with Laser-Patterned Serpentine Interconnects

Dual-Use Strain Sensors for Acoustic Emission and Quasi-Static Bending Measurements

A Flexible Strain Sensor of Porous Conductive Silicone Rubber Composites Prepared from High Internal Phase Emulsion

Development of Flexible ZnO Thin Film Surface Acoustic Wave Strain Sensors on Ultrathin Glass Substrates

A Novel Ultra-Thin and High Toughness Piezoelectric Thin Film Sensor Based on MEMS Technology

Ultra-Wide Range, High Sensitivity Piezoresistive Sensor Based on Triple Periodic Minimum Surface Construction

Design Of A Novel Piezoelectric Acoustic Sensor Using Surface Micromachining

Novel Surface Acoustic Wave Temperature-Strain Sensor Based on LiNbO3 for Structural Health Monitoring

Heteroepitaxy of flexible piezoelectric Pb(Zr0.53Ti0.47)O3 sensor on inorganic mica substrate for lamb wave-based structural health monitoring

Highly Sensitive Flexible Resistance Strain Sensor Based on PDMS and Silver Nanowire

An Ultrasensitive Perovskite Single‐Model Plasmonic Strain Sensor Based on Piezoelectric Effect