Abstract:Piezoelectric wafer active sensors (PWAS) have been proven a valuable tool in structural health monitoring. Piezoelectric wafer active sensors are able to send and receive guided Lamb/Rayleigh waves that scan the structure and detect the presence of incipient cracks and structural damage. In-situ thin-film active sensor deposition can eliminate the bonding layer to improve the durability issue and reduce the acoustic impedance mismatch. Ferroelectric thin films have been shown to have piezoelectric properties that are close to those of single-crystal ferroelectrics but the fabrication of ferroelectric thin films on structural materials (steel, aluminum, titanium, etc.) has not been yet attempted. In this work, in-situ fabrication method of piezoelectric thin-film active sensors arrays was developed using the nano technology approach. Specification for the piezoelectric thin-film active sensors arrays was based on electro-mechanical-acoustical model. Ferroelectric BaTiO3 (BTO) thin films were successfully deposited on Ni tapes by pulsed laser deposition under the optimal synthesis conditions. Microstructural studies by X-ray diffractometer and transmission electron microscopy reveal that the as-grown BTO thin films have the nanopillar structures with an average size of approximately 80 nm in diameter and the good interface structures with no inter-diffusion or reaction. The dielectric and ferroelectric property measurements exhibit that the BTO films have a relatively large dielectric constant, a small dielectric loss, and an extremely large piezoelectric response with a symmetric hysteresis loop. The research objective is to develop the fabrication and optimum design of thin-film active sensor arrays for structural health monitoring applications. The short wavelengths of the micro phased arrays will permit the phased-array imaging of smaller parts and smaller damage than is currently not possible with existing technology.

Design Of A Novel Piezoelectric Acoustic Sensor Using Surface Micromachining

Hierarchically Structured Hollow PVDF Nanofibers for Flexible Piezoelectric Sensor

A Piezoelectric Micropumping Device

Design of Piezoelectric Resonant Sound Emission Receiver Sensor

Micromachined Piezoelectric Acoustic Device

Ferroelectric Thin-Film Active Sensors for Structural Health Monitoring

Micromachined piezoelectric devices for acoustic applications

Design and Analysis of a PZT-based Micromachined Acoustic Sensor with Increased Sensitivity

Fabrication and Characterization of A Micromachined Acoustic Sensor with Integrated Optical Readout

Flexible capacitive pressure sensor array using acoustic-assisted fabrication of microstructures as surface and dielectric layers

Micro Acoustic Devices Using Piezoelectric Films

Micromachined piezoelectric sensor with radial polarization for enhancing underwater acoustic measurement

New Solid-State Acoustic Motion Sensors: Sensing Potential Estimation for Different Piezo Plate Materials

Modelling and Characterisation of a Micromachined Resonant Pressure Sensor with Piezoelectric Excitation and Sensing

A Novel Piezoresitive Microphone MEMS Sensor For Aerospace Applications

Design, fabrication and reliability study of piezoelectric ZnO based structure for development of MEMS acoustic sensor

Structural Engineering in Piezoresistive Micropressure Sensors: A Focused Review

A Novel Structure for Pzt-Based Piezoelectric Microphone

A Novel Fabrication Methodology for Micromachined Sensor-Arrays with Multi-Thickness Configuration

Piezoelectric ceramics with hierarchical macro- and micro-pore channels for sensing applications

Piezoelectric Micromachined Microphone with High Acoustic Overload Point and with Electrically Controlled Sensitivity