Abstract:A wideband low-noise amplifier (LNA) featuring transformer-based wideband input matching is proposed for millimeter-wave applications. By analyzing the properties of conventional series input matching networks, which were widely employed in narrowband LNAs and shunt-series matching networks for bandwidth extension, a novel input matching network possessing the merits of both was proposed. For further bandwidth extension, another peak of input impedance at a higher frequency is introduced for the proposed input matching network. Moreover, it is proved that the proposed input matching network can suppress the gate resistor noise, resulting in significant noise figure (NF) improvement of an LNA. On the other hand, the NF is further reduced by connecting a transformer between the two amplification stages, which helps suppress the noise contribution from the second stage, leading to an LNA design with NF lower than 4.5 dB over a very wide operating bandwidth. To enhance the gain bandwidth, the peak distribution, including both shunt peaking and series peaking, is discussed. By appropriately distributing these peaks, which is also known as the pole-tuning technique, a wider gain bandwidth can be obtained. To validate the proposed techniques, an LNA with two common-source (CS) stages is designed and fabricated using a 65-nm CMOS process, and the overall chip size, including all pads, is only 0.26 mm². The two CS stages are cascoded for dc biasing to reduce the power consumption. Experimental results show that a peak gain of 13.5 dB is achieved within a -3-dB bandwidth from 19.2 to 42.6 GHz. The measured NF is 3.1-4.5 dB, and the input 1-dB gain compression point (IP1 dB) ranges from -13.54 to -9.89 dBm in the entire gain bandwidth. The input return loss S₁₁ is less than -10 dB over a frequency range of 16.8-38.9 GHz. Moreover, benefiting from the current-reuse technique, the power consumption of the LNA is only 6.36-mW.

Transformer Based Broadband Matching

Analysis and Design of Broadband, Transformer Based Matching Network

A Broadband High-Efficiency Quasi Class E Internally-matched GaN Power Amplifier with a Compact Band-Pass Output Matching Structure

A 22.8 GHz to 32.8 GHz Compact Power Amplifier with a 15 Dbm Output P1dB and 36.5% Peak PAE in 65-Nm CMOS.

A broadband, high isolation millimeter-wave CMOS power amplifier using a transformer and transmission line matching topology

Broadband matching variable-gain low-noise amplifier

Fully integrated pseudo differential K-band power amplifier in 0.13um standard CMOS

Three-solenoid Windings Transformer Baluns on CMOS-grade Silicon Substrate

Design of X/Ku Dual-Wideband GaN Power Amplifier MMIC Based on Coupled Multiresonator Matching Networks

Design and Analysis of a 26–34.5-Ghz Power Amplifier with Balanced Mismatch Reduction and Interstage Matching

A Compact 144% Fractional Bandwidth CMOS Power Amplifier With an Optimization of Synthesized High-Order Matching Network.

A $Ka$-Band Broadband Power Amplifier with Transformer-Based Lossy Magnetically Coupled Resonator Network: Analysis and Design

A 10.56-Ghz Broadband Transceiver with Integrated T/R Switching Via Matching Network Reuse and 0.3–2.1-Ghz Baseband in 28-Nm CMOS Technology

A broadband continuous class‐B/J power amplifier with novel output matching network

A 7W, 2.5-5GHz Wideband GaN PA with Transformer-Based Matching Network.

Millimeter Wave Transformer Coupled Low-Power and Broadband Power Amplifiers

Broadband and Highly Efficient Class-J Power Amplifier with Compact Output Matching Network

A Wideband CMOS LNA Using Transformer-Based Input Matching and Pole-Tuning Technique

A Broadband Monolithic Balun Based on 0.13μ CMOS m Process Using Planar-Spiral Transformers

A Broadband Monolithic Balun Based on 0.13/spl mu/m CMOS Process Using Planar-Spiral Transformers

A K-band Wideband Power Amplifier in 40-Nm CMOS with 7.6-Dbm Output Power