Abstract:Ti–6Cr–5Mo–5V–4Al (Ti-6554) alloy has wide applications for large load-bearing components in the aerospace field. However, during the hot forming process of the alloy in the α+β phase region, there are a variety of interaction and restriction softening mechanisms and complex texture evolution behaviors, which jointly affect the microstructure and mechanical properties. This paper systematically studies the softening mechanism and texture evolution of Ti-6554 alloy in the α+β phase region using electron backscatter diffraction (EBSD), including dynamic phase transformation (DPT) and dynamic spheroidization of α phase and dynamic recrystallization (DRX) of β phase. Firstly, the effect of deformation parameters on the DPT is studied, and it is found that the volume fraction of α phase declines gradually with raising the strain rate, deformation temperature and deformation amount. The yield stress and the driving force for DPT increase with raising the strain rate and decreasing the deformation temperature. The equiaxed α phase will gradually transform into the lamellar α phase during the spheroidization process, accompanied by the wedging of the β phase. The combined effect of DPT and dynamic spheroidization leads to α grain refinement. Furthermore, the effect of deformation parameters on the DRX process of β phase is also investigated. The DRX degree only increases gradually with increasing the strain. Increasing the deformation temperature and decreasing the strain rate do not significantly increase the DRX volume fraction. Meantime, the DRX process of the β phase is heavily dependent on the α phase. The higher proportion of the α phase is capable of promoting continuous dynamic recrystallization (CDRX) process of β phase, while the lower proportion of the α phase will promote the transformation of CDRX into dynamic recrystallization (DDRX), but can not effectively increase the DRX degree of β phase. Further, the texture evolution shows that due to the combined effect of DPT and dynamic spheroidization, the effect of deformation parameters on the texture strength of α phase is very complicated. For the β phase, and fiber textures are easily formed during the deformation process.

Microstructure Evolution and Its Effect on Flow Stress of TC17 Alloy During Deformation in Α+β Two-Phase Region

Flow Behavior and Microstructure Evolution of TB8 Alloy During Hot Deformation Process

Flow softening and microstructural evolution of near β titanium alloy Ti-35421 during hot compression deformation in the α+β region

Hot deformation behavior and microstructure evolution of TC11 dual-phase titanium alloy

Hot Deformation Behavior of a Novel Near-β Titanium Alloy Ti-5.5Mo-6V-7Cr-4Al-2Sn-1Fe in (α+β) Phase Region

The relationship between flow behavior and initial microstructure of Ti-10V-2Fe-3Al alloy during subtransus deformation

Constitutive Model and Microstructure Evolution of a Novel TG6 High-Temperature Titanium Alloy during Hot Deformation

Interaction of Microstructure Evolution Mechanism in Ti-0.3Mo-0.8Ni Alloy with Initial Lamellar Microstructure During Isothermal Compression below the Β-Transus

Study on High-Temperature Flow Behavior and Substructure and Texture Evolution of TA15 Titanium Alloy

Investigation of hot deformation behavior and microstructure evolution of TC18 alloy and establishment of constitutive equation under friction-temperature correction

Constitutive Model and Microstructure Evolution of Ti65 Titanium Alloy

Effect of high strain rate hot compression on the microstructure evolution and subsequent α precipitation of TC17 alloy during single-step and duplex aging

Microstructure Evolution of a Ti–Al–Sn–Zr Based Alloy During the Hot Compression Deformation

Microstructural Variation and a Physical Mechanism Model for a Ti-55511 Alloy during Double-Stage Hot Deformation with Stepped Strain Rates in the β Region

Microstructural evolution and FCC twinning behavior during hot deformation of high temperature titanium alloy Ti65

Investigation on the microstructure evolution and dynamic recrystallization mechanisms of TiAl alloy at elevated temperature

Systematic analysis of the softening mechanism and texture evolution of Ti–6Cr–5Mo–5V–4Al alloy during hot compression in α+β phase region

Microstructural characteristics and recrystallization mechanism of Ti-6.5Al–2Zr–1Mo–1V alloy during two-stage hot deformation

Effect of deformation and cooling on non-equilibrium microstructure evolution and phase-transition mechanism of Ti–6Al-2.5Mo-1.5Cr-0.5Fe-0.3Si

Hot deformation characteristic of TC21 titanium alloy with lamellar microstructure

Dynamic microstructural evolution of Al-Cu-Li alloys during hot deformation