Abstract:Piezo-driven dispensers are precision dispensing devices for trace amounts of fluid and are widely used in the microelectronics packaging field. However, the preloading mechanism of piezo-driven dispensers easily loosens in high-frequency operation, and the design accuracy of the transmission ratio of the flexible displacement transmission mechanism (DTM) requires improvement. To address the aforementioned problems, we designed a self-locking preloading mechanism with an adjustable preloading amount for piezo-driven flexible transmission dispensers and investigated the method of designing the transmission ratio considering the non-expected directional deformation (parasitic deformation). First, the principle of the preloading mechanism was analyzed, and a method for adjusting the droplet diameter based on the preloading amount was proposed. Second, an asymmetric flexible-hinge compliance matrix calculation method was proposed, a transmission ratio model of the DTM was established, and the influence law of the structural parameters on the transmission ratio was comparatively analyzed using ANSYS software. Based on the output displacement requirement, transmission ratios were designed and structural parameters were determined. Finally, based on the piezoelectric coupling simulation, a piezo-driven dispenser was manufactured, and a test platform was built to conduct the relevant tests. The simulation and test results demonstrated that the maximum relative errors of the transmission-ratio calculated by the proposed transmission-ratio model were 1.54% and 3.6 %, respectively, compared to the simulation and test results, confirming that the model was correct. Single-factor tests confirmed that a preloading mechanism can fix and preload the piezostack and that the droplet diameters can be adjusted with the preloading amounts. The operating frequency was up to 800 Hz with a diameter of 0.30 mm and a consistency of 4.32%, which meet the requirements of dispensing efficiency in the microelectronics packaging field. This study has practical significance for enhancing the transmission ratio design accuracy and dispensing performance of dispensers.

Experimental Investigation of Piezo-actuated Jet Dispensing Via a Flexible Hinge Displacement Amplifier

A Novel Piezostack-Driven Jetting Dispenser with Corner-Filleted Flexure Hinge and High-Frequency Performance

Design and Experiment of a Jetting Dispenser Driven by Piezostack Actuator

Design and performance analysis of a piezoelectric jetting dispensing valve

Design and performance analysis of an embedded amplified piezoelectric jetting dispensing valve

Direct-Acting Piezoelectric Jet Dispenser with Rhombic Mechanical Amplifier

Design and performance analysis of a flexible-hinged piezoelectric driving dispenser

Design and Experiment of a Needle-Type Piezostack-Driven Jetting Dispenser Based on Lumped Parameter Method

The Design and Evaluation of a High-Speed Jet Dispenser Driven by Single Piezoelectric Stack

Design and Analysis of Slight-Jet System Based on Firing Pin Principle for High Viscosity Adhesives

Design and analysis of a piezostack driven jetting dispenser for high viscosity adhesives

Optimizing dispensing performance of needle-type piezoelectric jet dispensers: A novel drive waveform approach

Design and analysis of a piezo-actuated hydraulic micro-displacement amplifier with high bandwidth and large amplification ratio

Design Of A Piezoelectric Exciter Actuator For Micro-Displacement Control - Theory And Experiment

A Novel High-Speed Jet Dispenser Driven by Double Piezoelectric Stacks

Dynamic Hysteresis Model and Control Methodology for Force Output Using Piezoelectric Actuator Driving

Development of A Piezoelectric-Actuated Drop-On-Demand Droplet Generator Using Adaptive Wavelet Neural Network Control Scheme

Simulation Analysis of Jetting Dispenser Based on Two Piezoelectric Stacks

Effect of Enhanced Squeezing Needle Structure on the Jetting Performance of a Piezostack-Driven Dispenser

Research And Development Of Piezo-Actuator Driven Micro-Displacement System With Three Degrees Of Freedom

Design and Experiments of a Novel Micro-Displacement Mechanism Based on Piezoelectricity Actuator