Abstract:To address the challenges posed by large propagation loss and severe multipath delay spread, while aiming to improve communication rates in long-range underwater acoustic (UWA) communication, this paper introduces a novel approach: multi-beam (MB) Orthogonal Frequency Division Multiplexing (OFDM) based on deconvolved conventional beamforming (dCv). The proposed method establishes a signal processing framework for UWA channel receivers, wherein received signals corresponding to each angle beam are isolated and concentrated using the dCv technique. Subsequently, the separated signals from each angle undergo maximal-ratio combining (MRC) channel equalization followed by demodulation. Compared to conventional single-beam (SB) processing methods, the proposed approach capitalizes on multipath diversity gain achieved by combining MB outputs originating from various arrival angles. Moreover, employing dCv processing demonstrates superior performance compared to popularly employed beamforming techniques, especially when dealing with paths arriving from closely aligned angles. Additionally, the array beamforming utilized significantly enhances the signal-to-noise ratio (SNR) of each beam output, mitigating the elevated error rates in channel estimation associated with combining low SNR signals received from individual elements. Simulation results utilizing BELLHOP and experimental data from the South China Sea showcase notably improved bit error rate (BER) performance for the proposed method compared to SB equalization, MB-MRC equalization based on conventional beamforming (CBF), minimum variance distortionless response (MVDR), and worst-case performance optimization (WCPO), as well as standard MRC equalization techniques. The proposed receiver achieves error-free decoding results at a communication distance of 80 km with a data rate of 247 bps.

Data Packet Structure and Modem Design for Dynamic Underwater Acoustic Channels

Orthogonal Frequency-Division Multiplexing Underwater Acoustic Communications with Time Reversal Processing

A Dedicated MAC Protocol Package for Real-Time Ocean Current Field Estimation Using Distributed Underwater Acoustic Sensor Networks.

A Coherent Underwater Acoustic Communication System Based on Joint Iterative Equalization and Decoding Algorithm

Designing an Adaptive Acoustic Modem for Underwater Sensor Networks

OFDM-IDMA Communications over Underwater Acoustic Channels

Single carrier FDMA over underwater acoustic channels

Time-varying Doppler Compensation for Orthogonal Frequency Division Multiplexing-Based Underwater Acoustic Communications

High-speed Underwater Acoustic Communication System Based on OAM-OFDM Index Modulation

Interference Cancellation for UWA Random Access Data Packet Transmission

Multi-band OFDM for Underwater Acoustic Communications

Adaptive Retransmission Scheme for Underwater Acoustic Nodes Based on Distance Ranging

A journey toward modeling and resolving doppler in underwater acoustic communications.

Synchronization Signal Identification and Parameter Estimation Based on Delay Autocorrelation Method

Differential spatial modulated OFDM in underwater acoustic communications

High-spectral-efficiency underwater acoustic communication with integrated phase tracking and timing resampling in fast time-varying scenarios

An Underwater Time Reversal Communication Method Using Symbol-Based Doppler Compensation with a Single Sound Pressure Sensor

Asynchronous Amplify-and-forward Relay Communications for Underwater Acoustic Networks.

Rate and Reliability Oriented Underwater Acoustic Communication Schemes

Characterization and modeling of high-speed underwater acoustic communication channels

High-performance deep-sea long-range underwater acoustic communication: Deconvolved conventional beamforming based approach