Abstract:To address the challenges posed by large propagation loss and severe multipath delay spread, while aiming to improve communication rates in long-range underwater acoustic (UWA) communication, this paper introduces a novel approach: multi-beam (MB) Orthogonal Frequency Division Multiplexing (OFDM) based on deconvolved conventional beamforming (dCv). The proposed method establishes a signal processing framework for UWA channel receivers, wherein received signals corresponding to each angle beam are isolated and concentrated using the dCv technique. Subsequently, the separated signals from each angle undergo maximal-ratio combining (MRC) channel equalization followed by demodulation. Compared to conventional single-beam (SB) processing methods, the proposed approach capitalizes on multipath diversity gain achieved by combining MB outputs originating from various arrival angles. Moreover, employing dCv processing demonstrates superior performance compared to popularly employed beamforming techniques, especially when dealing with paths arriving from closely aligned angles. Additionally, the array beamforming utilized significantly enhances the signal-to-noise ratio (SNR) of each beam output, mitigating the elevated error rates in channel estimation associated with combining low SNR signals received from individual elements. Simulation results utilizing BELLHOP and experimental data from the South China Sea showcase notably improved bit error rate (BER) performance for the proposed method compared to SB equalization, MB-MRC equalization based on conventional beamforming (CBF), minimum variance distortionless response (MVDR), and worst-case performance optimization (WCPO), as well as standard MRC equalization techniques. The proposed receiver achieves error-free decoding results at a communication distance of 80 km with a data rate of 247 bps.

A journey toward modeling and resolving doppler in underwater acoustic communications.

A novel synchronized methods of underwater acoustic signal scheme based on DSPs

Experimental demonstration of time reversal communication in doubly dispersive underwater channels

Experimental Studies of Time-Reversal Underwater Acoustic Communications

Orthogonal Frequency-Division Multiplexing Underwater Acoustic Communications with Time Reversal Processing

A Coherent Underwater Acoustic Communication System Based on Joint Iterative Equalization and Decoding Algorithm

Single carrier FDMA over underwater acoustic channels

Integrated Communication and Signal Processing for Distributed Underwater Sensing

A Wideband MIMO Underwater Acoustic Communication Experimental System

OFDM-IDMA Communications over Underwater Acoustic Channels

In-Band Full-Duplex Communications for Underwater Acoustic Networks.

Multi-band OFDM for Underwater Acoustic Communications

Asynchronous Amplify-and-forward Relay Communications for Underwater Acoustic Networks.

Direct Acoustic Communication Between Underwater and Airborne Nodes

Time-varying Doppler Compensation for Orthogonal Frequency Division Multiplexing-Based Underwater Acoustic Communications

Characterization and modeling of high-speed underwater acoustic communication channels

An Underwater Time Reversal Communication Method Using Symbol-Based Doppler Compensation with a Single Sound Pressure Sensor

Influence of Temporal and Spatial Fluctuations of the Shallow Sea Acoustic Field on Underwater Acoustic Communication

Doubly-Spread Channel Equalization Based on Channel Shortening in Underwater Distributed Acoustic Sensing Communications

Doppler estimation and timing synchronization of underwater acoustic communication based on hyperbolic frequency modulation signal

High-performance deep-sea long-range underwater acoustic communication: Deconvolved conventional beamforming based approach