Abstract:Purpose - The dimple is adopted into a double wall cooling structure which is widely used in hot gas components to increase the heat transfer effects with relatively low pressure drop penalty. The purpose of this paper is to study the effect of dimple depth and dimple diameter on the target surface heat transfer and the inlet to outlet friction factor.Design/methodology/approach - The study is carried out by using the numerical simulations. The impingement flow is directly impinging on the dimple and released from the film holes after passing the double wall chamber. The ratio between dimple depth and dimple diameter is varied from 0 to 0.4 and the ratio between dimple diameter and impingement hole diameter is ranging from 0.5 to 3. The Reynolds number is between 10,000 and 70,000. Results of the target surface Nusselt number, friction factor and flow structures are included. For convenience of comparison, the double wall cooling structure without the dimple is considered as the baseline.Findings - It is found that the dimple can effectively enhance the target surface heat transfer due to thinning of the flow boundary layer and flow reattachment as well as flow recirculation outside the dimple near the dimple rim especially for the large Re number condition. However, the stagnation point heat transfer is reduced. It is also found that for a large dimple depth or large dimple diameter, a salient heat transfer reduction occurs for the toroidal vortex. The thermal performance indicates that the intensity of the heat transfer enhancement depends upon the dimple depth and dimple diameterOriginality/value - This is the first time to adopt a dimple into a double wall cooling structure. It suggests that the target surface heat transfer in a double wall cooling structure can be increased by the use of the dimple. However, the heat transfer characteristic is sensitive for the different dimple diameter and dimple depth which may result in a different flow behavior

Parametric Study and Optimization of Dimpled Tubes Based on Response Surface Methodology and Desirability Approach

A Numerical Study On Fluid Flow And Heat Transfer Performance Of Internally Roughened Tubes With Dimples

Evaluation of thermal hydraulic flow and enhancement of heat performance in different 3D dimpled tube configurations according to design of experiment analysis

Heat transfer and hydrodynamics analysis of a novel dimpled tube

The Structural Optimization of Dimple in Microchannel for Heat Transfer Enhancement

Numerical simulation of dimled tubes for heat transfer enhancement

Multi-Objective Optimization Of The Dimple/Protrusion Channel With Pin Fins For Heat Transfer Enhancement

Three-Dimensional Numerical Study of Fluid and Heat Transfer Characteristics of Dimpled Fin Surfaces

Prediction and Analysis of Thermal‐hydraulic Performance of Tubes with Teardrop Dimples Based on Artificial Neural Networks

Heat Transfer and Friction Characteristics for Turbulent Flow of Dimpled Tubes

Heat Transfer Analysis on Dimple Geometries and Arrangements in Dimple Jacketed Heat Exchanger

A Numerical Investigation of Dimple Effects on Internal Heat Transfer Enhancement of A Double Wall Cooling Structure with Jet Impingement

Numerical Analysis of Heat Transfer Characteristics in a Pin Fin-Dimpled Channel with Different Pin Fins and Dimple Locations

Numerical study of the convective heat transfer enhancement in the micro channel with dimples and cylindrical grooves

Heat Transfer and Friction Factor in A Dimple-Pin Fin Wedge Duct with Various Dimple Depth and Converging Angle

Numerical investigation of flow and heat transfer in enhanced tube with slot dimples

Numerical Analysis of Flow Structure and Heat Transfer Characteristics in Dimpled Channels with Secondary Protrusions

Study the influence of concavity shapes on augmentation of heat‐transfer performance, pressure field, and fluid pattern in three‐dimensional pipe

A Parametric Optimization Framework for Fin-and-tube Heat Exchangers Based on Response Surface Methodology and Artificial Intelligence

Optimization of H-type finned tube heat exchangers with combinations of longitudinal vortex generator, dimples/protrusions and grooves by Taguchi method

Parametric Study and Optimization of H-type Finned Tube Heat Exchangers Using Taguchi Method