Abstract:In-service commercial aero-engine controls its thrust by controlling parameters such as speed/pressure ratio (Nf/EPR) characterized as measurable and indirectly related to the thrust. However, the mapping relationship between the Nf/EPR and the thrust would have unknown and nonlinear changes with the engine performance degrades, naturally causing it difficult to obtain the desired thrust by primarily designed Nf/EPR control and resulting in task degradation. Therefore, this paper proposes an improved double closed-loop self-adaptive performance recovery control method to yield the engine to maintain almost consistent performance in the whole life cycle. Firstly, the inner control loop of speed is designed based on the MPC algorithm to obtain the optimal fuel output through receding horizon optimization to improve the control performance. Secondly, the speed command from the inner control loop of the degraded engine is compensated by adding an outer control loop of thrust to maintain the desired thrust. In this control method, an improved high-precision parameter estimation method is present to estimate unmeasurable engine performance parameters. A steady-state identification algorithm therein is designed to judge the engine state to deal with the problem that the estimator might diverge due to the engine's strongly nonlinear performance changes under the circumstances of high dynamic operation. Finally, the simulation results show that, compared with the traditional method, the proposed method achieves the estimator's stable work, improves the control performance by 25.8%, and maintains the desired thrust in case of engine degradation.

Double Closed-Loop Controller Design for Boost Pressure Control of Turbocharged Gasoline Engines

On Boost Pressure Control Of Diesel Engines With Double-Layer Passage Turbocharger

Model-based Improved Advanced Adaptive Performance Recovery Control Method for A Commercial Turbofan Engine

The Nonlinear Single Controller Of Dgen380 Aero Engine Design

Nonlinear Control of Turbofan Engines: an Active Set-Based Method for Performance Optimization

Control of Diesel Engines with Electrically Assisted Turbocharging Through an Extended State Observer Based Nonlinear MPC

Sensor selection and controller design method with application to turbocharged stoichiometric spark-ignited engine controls with low pressure EGR

Research on nonlinear model predictive control of regulated two-stage turbocharging system of diesel engine at high altitudes

An Integrated Controller Design for a Small Aero-Engine

Dual-Loop μ-Synthesis Direct Thrust Control for Turbofan Engines

An adaptive synergetic controller applied to heavy-duty gas turbine unit

Tuneable model predictive control of a turbocharged diesel engine with dual loop exhaust gas recirculation

Adaptive Dual Closed Loop Speed Control with Throttle Valve Dynamics for Natural Gas Engine in Range-Extended Electric Vehicles

Off-Equilibrium Linearization-Based Control of Nonlinear Time-Delay System and Application to a Turbofan Engine

Nonlinear Design Method for Improving Aero-Engine Control Performance

Constraint Performance Pressure Tracking Control with Asymmetric Continuous Friction Compensation for Booster Based Brake-by-wire System

Multi-Input Multi-Output Robust Control of Turbofan Engines Based on Off-Equilibrium Linearization Linear Parameter Varying Model

Single Neuron PID Control of a Turbofan Engine with Inlet Pressure Distortion

Adaptive Finite‐time Control for Turbo‐generator of Power Systems with Prescribed Performance

Closed-loop Control for Diesel Engine Air Systems Equipped with Vacuum Actuators

Turbofan engine control design using robust multivariable control technologies