Abstract:Using molecular dynamics (MD) simulation, the influence of crystallographic orientation on the mechanical properties and microstructure evolution of the single-crystal CoCrFeMnNi high-entropy alloy as a face-centered cubic (FCC) metal is explored and quantified by nanoindentation. At the elastic stage of P-h curve, the results of MD-simulation are almost consistent with that of Hertz contact theory fitting, which ensures the accuracy of our results. The plastic deformation is studied by correlating the P-h curve with the instantaneous defect structure, and dominated by nucleation of Shockley partial dislocations or the movements of stacking faults. Furthermore, we discuss the effects of crystallographic orientations[001],[110], and [111] on the mechanical response of materials and the microstructure evolution. The slip mode and the stress-concentrated region are controlled by the crystallographic orientations, and an obvious pop-in behaviors are viewed in [111]-oriented sample, without appearing in other samples. The microstructure evolution exhibits distinct anisotropy causing the discrepancy of dislocation density and hardness. By analyzing the evolution of dislocation density and hardness, the linear relationship between the square root of dislocations density and hardness is revealed, and in good agreement with the classic Taylor hardening expression where the pre-factor is strongly dependent on the crystallographic orientation. In the study, the atomistic results are consistent with those predicted by the classic continuum mechanical theory, which contributes to the application of classic mechanical theory in molecular dynamics simulation.

Orientation dependence of damping behavior in a Mn-Cu shape memory alloy

Mechanism of internal friction in Cu–Al–Mn shape memory alloy

On the internal friction due to the twin boundary-h interaction in martensite

Relaxation of twin boundaries in a Ni2MnGa single crystalline

In Situ Atomic Force Microscope Study of High-Temperature Untwinning Surface Relief in Mn-Fe-Cu Antiferromagnetic Shape Memory Alloy

Ultrahigh Anisotropic Damping in Ferromagnetic Shape Memory Ni–Mn–Ga Single Crystal

The Investigation Of Internal Friction On Antiferromagnetic Transition And Martensitic Transformation In Mn-Fe(Cu) Alloys

In-situ Study of Surface Relief Due to Cubic-Tetragonal Martensitic Transformation in Mn69.4Fe26.0Cu4.6 Antiferromagnetic Shape Memory Alloy

Rate dependent damping of single crystal CuAlNi shape memory alloy

THE BEHAVIOR OF INTERNAL FRICTION ASSOCIATED WITH THE PROCESS OF MARTENSITE-TYPE TRANSFORMATION

Effect of crystallographic orientation on mechanical properties of single-crystal CoCrFeMnNi high-entropy alloy

Effects of Frequency, Composition, Hydrogen and Twin Boundary Density on the Internal Friction of Ti50Ni50−xCux Shape Memory Alloys

Orientation dependence of microstructure deformation mechanism and tensile mechanical properties of Nickel-based single crystal superalloys: A molecular dynamics simulation

High isothermal internal friction over a large temperature range for dual-phase Ni–Mn–In magnetic shape memory alloy

fcc Antiferromagnetism and martensitic transformation m Fe-Mn-Si based alloys

Influence Of Annealing On The Damping Behavior Of Ni-Cu-Mn-Ga Ferromagnetic Shape Memory Alloys

In Situ Observation of Thermoelastic Martensitic Transformation of Cu-Al-Mn Cryogenic Shape Memory Alloy with Compressive Stress

The inhibiting effect of dislocation helices on the stress-induced orientation of S' precipitates in Al–Cu–Mg alloy

Quantitative Reorientation Behaviors of Macro-Twin Interfaces in Shape-Memory Alloy under Compression Stimulus in Situ TEM

On the A/D type twin boundary in 18R martensite of a Cu-Zn-Al alloy

Effects of texture on the damping characteristics of cold-rolled and annealed Ti 50 Ni 40 Cu 10 shape memory alloy