Abstract:Shock tube ignition delay times and species time history measurements for Primary Reference Fuels (PRFs) such as normal heptane provide targets for the validation of combustion models, which in turn are used to develop more fuel-efficient engines that have smaller environmental footprints. However, a review of the literature has revealed that most of the shock tube ignition delay time and species measurement data for normal heptane have been obtained at elevated pressures, rather than at relatively low pressures where many other important experimental techniques such as jet-stirred reactors and flow reactors can provide corroborating results. One central problem preventing previous shock tube studies from examining first-stage ignition at these lower pressures was that ignition times were too long under these conditions to be measured within the available shock tube test times. To address this issue, recent advances in shock tube techniques for achieving long uniform test times have been applied in order to measure low-pressure first-stage ignition times of normal heptane together with normal heptane fuel time-history records at times up to about 30 ms. These measurements were performed in the Negative Temperature Coefficient (NTC) region (T = 664 - 792 K) in lean mixtures (21%O-2/Ar, equivalence ratio phi = 0.5) at pressures of roughly P = 3.5 atm using both the conventional and Constrained Reaction Volume (CRV) shock tube filling strategies. The data have been used to evaluate the performance of several combustion models, have been compared with other higher-pressure shock tube first-stage ignition times in n-heptane/20-21%O-2 mixtures found in the literature, and have been fit using a two-zone Arrhenius model for first-stage ignition delay times. The results showed that some combustion models yield ignition delay time predictions that differ from the experimental results by as much as an order of magnitude, that under these conditions n-heptane first-stage ignition times scale by roughly P-0.71 but are insensitive to phi, and that the fraction of fuel remaining after first-stage ignition increases with increasing initial experimental temperature. (C) 2018 The Combustion Institute. Published by Elsevier Inc. All rights reserved.

Autoignition of Diesel/oxygen/nitrogen Mixture under Elevated Temperature in a Heated Shock Tube

Ignition Characteristics of Dual-Fuel Methane-N-hexane-oxygen-diluent Mixtures in a Rapid Compression Machine and a Shock Tube

Shock Tube Study on Auto-Ignition Characteristics of Kerosene/air Mixtures

Ignition delay time measurements of diesel and gasoline blends

Shock tube ignition delay time measurements in propane/O2/argon mixtures at near-constant-volume conditions

Shock Tube Study of Ignition-Delay Measurements and Kinetic Mechanism Research for Syngas

A shock tube study of the ignition delay time of DME/ammonia mixtures: Effect of fuel blending from high temperatures to the NTC regime

Shock tube and modeling study on autoignition properties of ammonia/diethyl ether mixtures at high temperatures

Constrained reaction volume shock tube study of n -heptane oxidation: Ignition delay times and time-histories of multiple species and temperature

Experimental and kinetic modeling study on auto-ignition of ammonia/n-heptane mixtures at intermediate temperatures

Non-uniform Ignition Behind a Reflected Shock and Its Influence on Ignition Delay Measured in a Shock Tube

Ignition Delay Time of Small Hydrocarbons-Nitrous Oxide (-Oxygen ) Mixtures

Shock tube and modeling study on the ignition delay times of ammonia/dimethoxymethane at high temperature

Experimental and numerical study on the ignition delay times of dimethyl ether/propane mixtures in O2/CO2 atmospheres

Investigating Auto-Ignition Behavior of N-Heptane/iso-octane/ethanol Mixtures for Gasoline Surrogates Through Rapid Compression Machine Measurement and Chemical Kinetics Analysis

Shock Tube Study of Normal Heptane First-Stage Ignition Near 3.5 Atm

Shock tube experiments and numerical study on ignition delay times of ammonia/oxymethylene ether-2 (OME 2 ) mixtures

Study on Ignition Delay of Kerosene Aerosol in Shock Tube

Aerosol Shock Tube Designed for Ignition Delay Time Measurements of Low-Vapor-Pressure Fuels and Auto-Ignition Flow-Field Visualization

Shock Tube Measurements of Species Time-Histories during Jet Fuel Pyrolysis and Oxidation

Shock Tube Study of Methylcyclohexane Ignition over a Wide Range of Pressure and Temperature