Abstract:Thermal interface materials (TIMs) are indispensable materials in thermal management, and Al2O3-based TIMs are most widely used in thermal managements. Surface modification is an effective method to improve Al2O3 dispersion in matrix, thereby increasing the maximum filler loading. However, traditional surfactants hardly promote the interfacial heat-transfer on the premise of the same filler loading. In this work, we proposed an electrostatic self-assembly strategy to functionalize the surface of Al2O3 particles with MXene sheets to enhance the interfacial heat-transfer between fillers and silicone rubber (SR). To validate the effectiveness of MXene, we compared the Al2O3-MXene-SR TIM with Al2O3-graphene-SR TIM and Al2O3-SR TIM under the same Al2O3 loading in the aspects of mechanical properties and thermal properties. Though MXene could increase the viscosity and hardness, the negative influence of MXene is much weaker than that of graphene. Nevertheless, the positive impact of MXene is more significant. First, it can reinforce the mechanical strength. The experiment showed the breaking tensile strength of the Al2O3-MXene-SR TIM is 0.117 MPa, higher than that of the Al2O3-graphene-SR TIM (0.082 MPa) and the Al2O3-SR TIM (0.07 MPa). Second, the thermal conductivity of TIMs improves a lot after MXene coating. The thermal conductivity of Al2O3-MXene-SR TIM is 3.4 W·m−1·K−1, with the matrix/filler mass ratio of 100:1600, which is 30% higher than that of the Al2O3-SR TIM (2.6 W·m−1·K−1) and 21% higher than that of Al2O3-Gr-SR TIM (2.8 W·m−1·K−1). Whereas the Al2O3 loading keeps the same and the MXene fraction is only about 1.16 vol‰, the increment of the thermal conductivity is mostly due to the improvement of interfacial heat-transfer via MXene. The temperature cycling test and aging test implied that the Al2O3-MXene-SR TIM is thermally stable and reliable. The underlying mechanism of the interfacial heat-transfer enhancement was revealed by the analysis of phonon density of states (PDOS) via a molecular dynamics simulation. The PDOS of MXene is more compatible with Al2O3 and SR than graphene, so MXene sheets play the role as a bridge between Al2O3 and SR to improve the interfacial phonon transport. This work provides an effective method to reduce interfacial thermal resistance in TIMs, which could facilitate the development of thermal management materials.

Phase Change Materials Coated with Modified Graphene-Oxide As Fillers for Silicone Rubber Used in Thermal Interface Applications

Comprehensive excellent performance for silicone-based thermal interface materials through the synergistic effect between graphene and spherical alumina

Enhancement of thermal conductivity and insulation of silicone thermal interface material through surface modification and synergistic effects of nanofillers for thermal management of electronic devices

RGO-Coated Polyurethane Foam/Segmented Polyurethane Composites as Solid–Solid Phase Change Thermal Interface Material

The improved thermal conductivity and heat dissipation capacity of elastomer‐based thermal interface materials through promoting the surface interactions and complete networks

Synergistic Enhanced Thermal Conductivity of Polydimethylsiloxane Composites Via Introducing SCF and Hetero-Structured GB@rGO Hybrid Fillers

Preparation and Thermal Properties of the Graphene-Polyolefin Adhesive Composites: Application in Thermal Interface Materials

Graphene-Assisted Thermal Interface Materials with a Satisfied Interface Contact Level Between the Matrix and Fillers

A graphene nanoflake-based flexible composite phase change material for enhanced heat dissipation in chip cooling

Reduced Graphene Oxide Embedded with MQ Silicone Resin Nano-Aggregates for Silicone Rubber Composites with Enhanced Thermal Conductivity and Mechanical Performance

Paving 3D interconnected Cring-C3N4@rGO skeleton for polymer composites with efficient thermal management performance yet high electrical insulation

Flexible Polyolefin Elastomer/Paraffin Wax/Alumina/Graphene Nanoplatelets Phase Change Materials with Enhanced Thermal Conductivity and Mechanical Performance for Solar Conversion and Thermal Energy Storage Applications

Synergistic Effects between Multiphase Thermal Insulation Functional Phases on the Mechanical and Heat Insulation Properties of Silicone Rubber Composites

Flexible Composite Films with Ultrahigh Through-plane Thermal Conductivity yet Low Graphene Content

The polymer-based thermal interface materials with improved thermal conductivity, compression resilience, and electromagnetic interference shielding performance by introducing uniformly melamine foam

Radiation Synthesis Of Polysilane-Modified Graphene Oxide For Improving Thermal Conductivity And Mechanical Properties Of Silicone Rubber

Promoting Thermal Conductivity of Alumina-Based Composite Materials by Systematically Incorporating Modified Graphene Oxide

High thermal conductivity of flexible polymer composites due to synergistic effect of multilayer graphene flakes and graphene foam

Novel slurry containing graphene oxide-grafted microencapsulated phase change material with enhanced thermo-physical properties and photo-thermal performance

Enhanced interfacial heat-transfer of Al2O3-MXene-silicone composite via an electrostatic self-assembly strategy

Enhanced thermal performance of hybrid interface materials supported by 3D thermally conductive SiC framework