Abstract:The MAX phase has attracted much attention due to its unique properties combined with the merits of both metal and ceramic, including the low density, high electrical conductivity and good oxidation resistance, which makes it significant for possible applications in various high temperature or other environments. There is a lot of research work on Ti2AlX (X=C, N). However little research about thermodynamic properties at high pressure is carried out. So we study the structural, mechanical and thermodynamic properties of Ti2AlC and Ti2AlN at various pressures and temperatures. The first-principles calculations based on electronic density-functional theory framework are used to investigate the properties at various pressures. The cut-off energy is 350 eV. Converged results are achieved with 10102 special K-point meshes. The self-consistent convergence of total energy is set to be 5.010-6 eV/atom. According to the calculated structural parameters at various pressures, we can find that the ratios V/V0 (V0 denotes the system volume at 0 GPa) of Ti2AlX are reduced by 20.59% and 18.93%, respectively, so the compressibility of the system is strong. As the internal pressure increases, the curves of V/V0 become gentle. Then we calculate elastic constants at pressures ranging from 0 to 50 GPa in steps of 10 GPa. It is obvious that the Ti2AlX is mechanically stable because all of the elastic constants satisfy the Born stability criteria. The bulk modulus, shear modulus and Young's modulus linearly increase with internal pressure increasing, implying that the pressure can improve the resistance to volume deformation. The ductility and brittleness can be judged according to Pugh's criterion (ratio of bulk modulus to shear modulus B/G), and the brittle nature turns into ductile nature in a pressure range of 40-50 GPa for the Ti2AlX since the value of B/G exceeds 1.75. Finally, we study the thermodynamic properties at various pressures and temperatures based on the quasi-harmonic Debye approximation theory, including the bulk modulus, heat capacity and thermal expansion coefficient. The bulk modulus decreases with temperature increasing but increases with pressure increasing. The heat capacity at constant volume Cv and the heat capacity at constant pressure Cp have the same variation tendency, while Cv obeys the Dulong-Petit limit. It is easy to see that temperature and pressure have opposite influences on heat capacity and the effect of temperature is more significant than that of pressure. The effects of temperature and pressure on linear expansion coefficient mainly occur at low temperature and the effect of pressure is not so considerable when the pressure exceeds 30 GPa. Above all, the effects of temperature and pressure on thermodynamic properties are inverse.

Equation of State of LiNi0.8Co0.1Mn0.1O2 at High Pressure

Equation of state of LiNi0·5Mn1·5O4 at high pressure

Equation of State and Electrical Transport Properties of Mixture of Li1.2Mn0.54Co0.13Ni0.13O2 and LiNi0.87Co0.09Mn0.03Al0.01O2 at High Pressure

Equation of State of LiCoO 2 under 30 GPa Pressure

Effect of pressure on the structural properties of Li[Li0.1Ni0.35Mn0.55]O2

Effect Of Pressure On The Structural Properties Of Li[Li0.1ni0.35mn0.55]O-2

Effect of pressure on the structural properties of Li [Li {sub 0.1} Ni {sub 0.35} Mn {sub 0.55}] O {sub 2}

Equation of State and Structural Studies of Na0.5coo2 under High Pressure

Effect of pressure on the structural properties of Li[Li01Ni035Mn055]O 2

Structural Transition of Mnnb2o6 under Quasi-Hydrostatic Pressure

Structural stability and electrical properties of AlB2-type MnB2 under high pressure

High Pressure Structural And Elastic Properties Of Nio Up To 67 Gpa

First-principles Study of Mechanical Properties and Electronic Structures of the Nickel-molybdenum Binary Compounds Under Pressure

Thermal Equation of State of Molybdenum Determined from in Situ Synchrotron X-ray Diffraction with Laser-Heated Diamond Anvil Cells

In situ synchrotron X-ray diffraction with laser-heated diamond anvil cells study of Pt up to 95 GPa and 3150 K

The Structural Stability of Mn3Sn Heusler Compound under High Pressure.

Half‐Metallic CoO2 and Semiconducting NiO2 at High Pressures

Structural, Mechanical, and Thermodynamic Properties of Ti2AlX (X = C, N) at High Pressure

Phase Transition and Vibration Properties of MnCO3 at High Pressure and High-Temperature by Raman Spectroscopy

Phase Transition Behavior of LiCr<sub>0.35</sub>Mn<sub>0.65</sub>O<sub>2</sub>under High Pressure by Electrical Conductivity Measurement