Abstract:A heating area of 190 mm x 90 mm large flat-plate loop heat pipe was designed for the heat dissipation problem of multi-heat sources. The design process was also briefly introduced. The evaporator was made of aluminum alloy, and heat dissipation fins were arranged on the back side of the compensation chamber to enhance the heat transfer between the compensation and the ambient. The stainless steel wire mesh worked as the porous wick, and the acetone was chosen as the working fluid. Six ceramics heating blocks were used as the heat sources. The results showed that the system could start up and work normally between 20 W-140 W, and maintained the heating surface temperature below 90 degrees C. The system behaved as a zigzag start below 20 W, and the condenser inlet temperature oscillated periodically, and the system could start up stably between 25 W and 140 W. When the heat load was increased, there occurred periodic temperature fluctuation in condenser outlet. The system could establish a new balance quickly during variable heat loads operation, which reflected the good reliability of the LHP. The experiment of changing the heat dissipation condition on the condenser side and the evaporator side was carried out. When the heat load was 120 W and the ambient temperature was constant, the system equilibrium temperature difference caused by the air ventilation of the condenser was changed, which was less than the heat dissipation of the evaporator under the same conditions. The evaporator thermal resistance decreased with the increase in heat load, and the minimum thermal resistance of 0.032 degrees C/W was achieved at the heat load of 120 W. The total thermal resistance of the LHP was distributed between 0.312 degrees C/W and 0.212 degrees C/W. It was also pointed out that it was very important to improve the thermal uniformity of the heated surface of a large-plane loop heat pipe system with multiple heat sources. (C) 2019 Elsevier Ltd. All rights reserved.

Experimental investigation of a miniature loop heat pipe with eccentric evaporator for cooling electronics

Simulation of Steady-State Operation of an Ejector-Assisted Loop Heat Pipe with a Flat Evaporator for Application in Electronic Cooling

Experimental Study on Miniature Loop Heat Pipe with Flat-Plate Evaporator

Experimental Study on Miniature Loop Heat Pipe with Flat Evaporator

EXPERIMENTAL INVESTIGATION OF THE WORKING PERFORMANCE OF A NOVEL MINIATURE LOOP HEAT PIPE

Experimental investigation of loop heat pipe with flat evaporator using biporous wick

Experimental study on thermal performance of loop heat pipe with a composite-material evaporator for cooling of electronics

Experimental Investigation on Temperature Oscillation in a Miniature Loop Heat Pipe with Flat Evaporator

Experimental Study on Loop Heat Pipe with Two-Wick Flat Evaporator

Experimental studies on a high performance compact loop heat pipe with a square flat evaporator

Experimental Investigation of Loop Heat Pipe with a Large Squared Evaporator for Cooling Electronics

Experimental Study of Heat Transfer Capacity for Loop Heat Pipe with Flat Disk Evaporator

Experimental investigation on the thermal performance of a novel loop heat pipe (LHP) with micro-channel structure

Heat Transfer Investigation of Miniature Flat Heat Loop Pipe Evaporator for Heat Dissipation of Electronic Apparatus

A Novel Miniaturized Loop Heat Pipe

Experimental study on operating parameters of miniature loop heat pipe with flat evaporator

An experimental study on applying miniature loop heat pipes for laptop PC cooling

Experimental study on a novel loop heat pipe with both flat evaporator and boiling pool

Experimental Investigation of Loop Heat Pipe with a Large Squared Evaporator for Multi-Heat Sources Cooling

Condenser design optimization and operation characteristics of a novel miniature loop heat pipe

Experimental investigation on thermal characteristics of a novel loop heat pipe for cooling high heat flux electronic chips