Abstract:Vehicles commonly suffer from the narrow-band noises and vibrations, usually a superposition of multiple sinusoidal signals, due to the excitations of engines, electrical motors, gear boxes, and other rotating mechanical parts. These excitations are transmitted to a reference point of some structure with certain transmission paths. The vibration signal measured at the reference point can be used for power system monitoring, fault diagnosis, modal analysis, noise analysis, etc. For convenience, researchers in a laboratory usually use shakers to generate expected narrow-band vibration signals acting on the vehicle structure reference points to simulate the vibration signals. However, there is a prominent difficulty in ensuring the amplitude and phase accuracy of each sub-frequency component simultaneously. In order to improve the accuracy of generating the expected vibration signal, this paper presents a multi-source vibration simulation control technology based on the tracking filter method. The main idea is to use the tracking filter to estimate the amplitude and phase of the target sub-frequency component accurately. Further, on the target sub-frequency, the drive signal of shakers is then corrected based on the amplitude and phase errors to achieve a more accurate target vibration signal. The amplitude and phase of each sub-frequency component in the excitation signal can be controlled independently. Compared with other Fast Fourier Transform (FFT)-based frequency domain analysis algorithms and numerical methods by solving the equations, the tracking filter method has a higher frequency resolution and higher accuracy. It can be easily realized in real time applications due to its simplicity. Finally, verification experiments are completed. The experimental results show that the multi-source vibration simulation control technology presented in this paper can achieve high-precision amplitude and phase on each sub-frequency component of the target vibration signals, which contain up to eight sub-frequency components.

Adaptive Vibration Control on Electrohydraulic Shaking Table System with an Expanded Frequency Range: Theory Analysis and Experimental Study

Research On Three-Variable Control Technology Of Seismic Simulating Shaking Tables

The Control Strategy Study for Hydraulic Shaking Table

Parameter-dependent Vibration-Attenuation Controller Design for Electro-Hydraulic Actuated Linear Structural Systems

Research On Control Technologies For A High-Precision Multi-Source Vibration Simulation System

Neural Network Based Adaptive Robust Control of a Single-Axis Hydraulic Shaking Table

Levelling Control of an Electro-pneumatic Stabilized Platform Driven by Pneumatic Muscles

Tracking Control Of An Electro-Hydraulic Shaking Table System Using A Combined Feedforward Inverse Model And Adaptive Inverse Control For Real-Time Testing

A Practical Adaptive Sinusoidal Vibration Control Strategy for Electro-Hydraulic Shake Table

Present Status and Prospect of High-Frequency Electro-hydraulic Vibration Control Technology

Adaptive Inverse Control of Time Waveform Replication for Electrohydraulic Shaking Table

Continuous Swept-Sine Vibration Realization Combining Adaptive Sliding Mode Control and Inverse Model Compensation for Electro-hydraulic Shake Table

Servo system of 6 DOF electro-hydraulic shaking table

Implementation of Electrohydraulic Shaking Table Controllers with a Combined Adaptive Inverse Control and Minimal Control Synthesis Algorithm

Modeling and Vibration Decoupling Control of Multi-Axial Shaking Table

Dynamic Analysis and Improvement of the Electrohydraulic System under Power Limitation Control.

Experimental Study of a New Kind of Double‐layer Shaking Table

Self-Tuning Pressure-Feedback Control by Pole Placement for Vibration Reduction of Excavator with Independent Metering Fluid Power System

Extended‐state‐observer‐based adaptive robust control of a single‐axis hydraulic shaking table

Research On The Control Strategy Of Hydraulic Shaking Table Based On The Structural Flexibility

Adaptive Feed-Forward Compensation for Hybrid Control with Acceleration Time Waveform Replication on Electro-Hydraulic Shaking Table