Abstract:An AMD control system is usually built based on the original model of a target building. As a result, the fact leads a large calculation workload exists. Therefore, the orders of a structural model should be reduced appropriately. Among various model-reduction methods, a suitable reduced-order model is important to high-rise buildings. Meanwhile, a partial structural information is discarded directly in the model-reduction process, which leads to the accuracy reduction of its controller design. In this paper, an optimal technique is selected through comparing several common model-reduction methods. Then, considering the dynamic characteristics of a high-rise building, an improved balanced truncation (BT) method is proposed for establishing its reduced-order model. The abandoned structural information, including natural frequencies, damping ratios and modal information of the original model, is reconsidered. Based on the improved reduced-order model, a new reduced-order controller is designed by a regional pole-placement method. A high-rise building with an AMD system is regarded as an example, in which the energy distribution, the control effects and the control parameters are used as the indexes to analyze the performance of the improved reduced-order controller. To verify its effectiveness, the proposed methodology is also applied to a four-storey experimental frame. The results demonstrate that the new controller has a stable control performance and a relatively short calculation time, which provides good potential for structural vibration control of high-rise buildings.

A Multi‐time‐delay Compensation Controller Using a Takagi–Sugeno Fuzzy Neural Network Method for High‐rise Buildings with an Active Mass Damper/driver System

A Compensation Controller Based on a Regional Pole-Assignment Method for AMD Control Systems with a Time-Varying Delay

A Compensation Strategy Using an H<sub></sub> Control Law for a Multi-Time-Delay Control System

Design and implementation of AMD system for response control in tall buildings

A Reduced-Order Controller Considering High-Order Modal Information of High-Rise Buildings for AMD Control System with Time-Delay

Hybrid Active Mass Damper (amd) Vibration Suppression of Nonlinear High-Rise Structure Using Fuzzy Logic Control Algorithm under Earthquake Excitations

Decoupled Adaptive Terminal Sliding Mode Control Strategy for a 6-DOF Electro-Hydraulic Suspension Test Rig with RBF Coupling Force Compensator

A Variable Gain State‐feedback Technique for an AMD Control System with Stroke Limit and Its Application to a High‐rise Building

A State Feedback Controller Based on GCC Algorithm Against Wind-Induced Motion for High-Rise Buildings with Parametric Uncertainties

Influence Analysis of a Higher-Order CSI Effect on AMD Systems and Its Time-Varying Delay Compensation Using a Guaranteed Cost Control Algorithm

A Stroke-Limitation AMD Control System with Variable Gain and Limited Area for High-Rise Buildings

Active Control of A Nonlinear and Hysteretic Building Structure with Time Delay

Adaptive Sliding Controller with Self-Tuning Fuzzy Compensation for Vehicle Suspension Control

Wide-area Time-delay Robust Damping Control Based on System Identification

Active Damping Control of the Large-scale Flexible Hydraulic Manipulators with Independent Metering System

Simultaneous Optimization of Damper Parameters and Controllers for Building Vibration Attenuation over Finite Frequency Band

AMD Control of Wind Response of Flexible-high Building Using Fuzzy Neural Network Forecast Algorithm

Establishment of AMD control system considering CSI effect and its time-varying delay compensation

An Observer-Based Controller with a LMI-Based Filter against Wind-Induced Motion for High-Rise Buildings

Model Reduction Techniques for High-Rise Buildings and Its Reduced-Order Controller with an Improved BT Method

Using real-time hybrid simulation for active mass damper experimentation and validation